amplifier

Wassup fellas Those who are running Audio control Lc2i as a Line output converter and have the alpine system, where are you tapping in for signal for your aftermarket sub??? I have tapped into the APH CH03 HAR-D harness (pink,purple and teal) colors and idly I’m getting feedback in my dash...

First post here have found a lot of useful information but can’t find the answers for my next step in upgrading my base 6 speaker stereo. It’s also my first time doing any car audio. I’ve added a ap4-ch41 and a 4 channel amp that drives 4ohms speakers my question is can I run 4ohm speakers in...

First time posting, long time reading the 5th Gen Ram forums. I am looking for recommendations/feedback on different options for line output converters for the 8.4/6-speaker audio system. I am planning to build a subwoofer box and add my 2 10" Pioneer TS-SW2502S4 subs and Pioneer GM-D9601 mono...

Hello everyone. 2021 Rebel with the 19 speaker Harman/Kardon system. I am replacing speakers while keeping the factory HK amplifier, and what I cannot determine is the accurate subwoofer to amplifier wiring configuration. I understand there are 3 voice coils on the subwoofer, each at 2.2ohms...

Has anyone installed a aftermarket subwoofer and amplifier in the 2019 Ram 1500 with the Harman Kardon audio system? I am planning to install two 12’s, amp, and a line output converter. Just curious if anyone has done this yet so I will know what problems to look out for. I already have looked...

** Newbie**I purchased the DSR1 to replace the factory amp. I’m running kicker Cxa 800.1 for my 2 10” subs. How can I wire the dsr1 for all the door speakers, dash speakers. Which amp? 4 channel? For 9 speakers? Or 6 channel? Has anyone installed the dsr1 with alpine system? Any info would be...

Hi I'm new here. I have a 2019 ram 1500 bighorn with the alpine 9 speaker sound system. I am trying to add a 12 inch alpine type r and a Rockford fosgate 1200d amplifier to the factory alpine system. I'm having a tough time finding a working diagram to figure out which wires to tap my pac lp7-2...