Search results

How’s the bell tech ride

Got ya man I’m coming from a leveled 2wd 19 classic with 20x12s and 305s, I got tired of rock chips and curb rashes lmao. Cheers brotha pics when u done!

I’m running 295/70/18 toyo at3 on 18x9 0mm offset which I believe is a 1/4” taller (34 1/4”) same width and I have a 2” level after I aligned no rubbing/scrubbing I think I could tuck 35s with minimal trim. But I also am a fan of the tucked look on these trucks

Go 35x12.50x20, or instant ragrets

Just removed mine and pulled off the plastic bar that rotates down & left the mechanix there, looks great gained about 3-5” extra ground clearance.

Well my leveling kit settled after about 10 miles and I sit completely level now. The ride is ok it definitely feels like a truck now and that is what I’m used too! The factory ride is so smooth I felt like I was in a Chrysler 300 so it is a big difference but I can’t complain. For the price I...

Also wondering if putting a little rake back in the rear would eliminate this rub (3/4-1”) because I had these wheels and tires stock and they cleared fine (close)

295/70/18 18x9 slight rub on mud flap, if she still runs after alignment might swap out for 285/75/18

No off-road package, I drove the truck 10 miles it settled back down and is now reading dead level! More than satisfied the truck drives and responds great better than stock. Still needing alignment tomorrow will post pics

Just installed this with sky jacker UCA, set on 2” setting called bell tech to confirm needed rings. Put everything back together and had a total of 3” of level I had one black 15mm spacer and 1 silver 16mm spacer left for each side. Not sure how this happened anyone else have this problem, will...

Another bell tech installer here, just installed bell tech struts set @ there 2” setting with sky jacker UCA. Fender height before on 295/70/18 was 37 3/4 front 39 1/2 rear After bell tech and skyjacker uca 40 1/2 front 39 3/4 rear followed there instructions to the T, even called before to...