Search results

It's common for several system to take a couple of key cycles to reinitialize after the battery has been disconnected. Backup cam, Uconnect, XM, etc.

If Hazard sense wire was removed from pin 21 it should be taped to the harness. Look for the WH/DB wire and reinsert to pin 21. The wire for the LED bed lights in pin 16 is BG/VT. View looking at wire insertion side C7 (G)

The Mopar bed lights kit 8221527AB instructions have a error on plug C7. The call out for Pin 16 is in the wrong position. That pin is actually the Hazard sense wire.

TSB for loose cable on tailgate

Thanks Neurobit. Very Informative.

I was going off what the owner manual says since the wiring diagrams are not available. From the Owners Manual: Automatic High Beam Headlamp Control — If Equipped The Automatic High Beam Headlamp Control system provides increased forward lighting at night by automating high beam control through...

So does the automatic high beam headlight camera also used for Lane Sense?

Does anybody know what components/modules are needed to add LaneSesne or if it can be done. I have the forward camera for the Rain Sensing wipers and was not sure if the LaneSense uses the same camera. 2020 Laramie Sport

Thanks James I just bought a 2020 Laramie and it had the same problem. Rear door ambient lights, under seats, floor board and ambient dash lights also did not work. I pulled the small panel and bolt by the rear door handle and could see part of the harness thru the clip holes on the left rear...