Search results

Smoked the 3rd brake light on my rebel…

I only sprayed the front of the skid plate. To prep I taped off and covered the front of the truck and undercarriage to prevent over spray. May of went a little overboard with the taping but wanted to make sure I didn’t get any bed liner anywhere I didn’t want it. I attached a picture for...

Thank you! It’s a 4” BDS lift which sits pretty level. Wheels are XD Grenade 20x10 w/ negative -24 offset wrapped in Toyo RT 35x12.5. I was on the fence about doing the skid plate as I didn’t know how it would turn out doing it myself… but wish I would have done it sooner now that it’s done...

Bed liner on the skid plate and painted the tow hooks…

After tow hooks…

I also used rustoleum bed liner spray without removing the skid plate. My only recommendation is to spray thin coats to prevent dripping. Happy with the look. Next up adding some color to the tow hooks…

I had this happen a few months after install of my lift. Took it back to the shop and they tightened the rear sway bar and sound is gone.

How was the install for this? Looks great. I have been eyeing the Baja Designs S8

Thanks for all the feedback everyone. There is some good info here!

Anyone have an experience with Baja Design S2 reverse lights? Any reviews on these and install advice is appreciated! https://www.bajadesigns.com/products/Dodge-Ram-Rebel-1500-19-On-Dual-S2-Reverse-Kit.asp The oem reverse light barely put out anything so looking for some light!

Awesome, thanks!

I bought one and like it. The canister takes up some bed space, but i expected that. It is convenient to open and close (can be done with tailgate open or closed) and low profile. If i had a complaint it would be when driving at high speed it will shimmer a little, but its still solid and in...

Your truck looks awesome! Could you post a pic of what the geometry looks like on all the angles under the truck?

Running into some issues with my 4” BDS lift on my 2019 Ram Rebel. The steering knuckle is contacting the lower control arm at full lock. More pics in this thread https://5thgenrams.com/community/threads/bds-lift-steering-knuckle-contacting-lca-uca-angle-question.24569/ Do any Rebel owners...

non air rebel 4"BDS. Details in signature.

Lol had to post this too

So just to be more exact I measured the clearance of my garage since it is a 7ft garage, but has rubber weather stripping that hangs down. The height to the weather stripping is 82 and 1/4 inches and it fits in my garage without hitting the weather stripping.

I just did the fit test for the garage for the first time. I have a 7ft garage and it surprisingly fits! Was a little sketchy first go around but I estimate the shark fin antenna had about a quarter of an inch of clearance.

Here’s a pic. And yes I meant top of fender opening. I forgot to take pre measurements, but I know some people have said they have saw over 4” in the front with BDS. At one point I did measure the rake and from memory thought it was just under 3” on my truck. So since it’s pretty level I’m very...

I measured from the ground to top of fender. Up fwd I see 43” even and in the rear 43 1/8”. So it’s pretty level with a hint of rake. Hope that helps.