5thGenRams Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Search results

  1. A

    Subwoofer in Harmon Kardon

    I have another thread where I complained about the same. Open the window all the way, which allows it to flex a lot more. Take a 2 inch x 1 inch piece of felt and stick it on the upper right part of the window that goes into the window track, and the same on the upper left. The upper left part...
  2. A

    New truck and factory defect rivet

    I highly advise against swapping doors... Its almost a guarantee it wont ever close properly or align properly. Plus since they have to paint the door, they will also have to blend the front fender, rear door, lower rocker and roof to match. While eventually you might have perfect rivets...
  3. A

    Dealership Frustrations

    Thought id help here since I was in the service industry for some time, including service advisor a while back... The issue with NPF or No Problem Found, is typically dealerships/manufacturers only offer .2 to .3 hours of time for diagnostic on most of these issues, IF any at all. That means...
  4. A

    Lowered the rear 2" last night.

    I didn't unbolt my sway bar either, springs came out with ease just by unbolting shocks.
  5. A

    Anyone else have rattles with the Harmon Kardon system?

    I found the hate thread in the interior forum... it was the back window, as you said. 60 seconds and some felt tape I had in my tool box, and back to perfect at any volume... I can even turn the bass to +2 if needed I only have 900 miles on the truck so I’m sure more rattles will appear now...
  6. A

    Anyone else have rattles with the Harmon Kardon system?

    While I didn’t expect it to be the same quality as the hk in my bmws, I at least figured keeping the bass on flat or below would create pleasant and rattle free tones, but alas, the domestic side is showing. Short of tearing the areas near the sub apart and going nuts with dynamat, has anyone...
  7. A

    Lowered the rear 2" last night.

    Just did mine... I’m sure it has to settle a bit still, I just went around the block. Looks like I have about 2 inches of clearance on the bump stops, so I may trim them if it settles much lower so I don’t smack them over bumps.
  8. A

    Lowered the rear 2" last night.

    Just pulled the trigger and snagged them today, same price for me. Reviews on their website were outstanding and most said ride was unaffected.
  9. A

    Lowered the rear 2" last night.

    Did you notice any change in ride quality? One of the biggest selling points for me on this truck is how well it rides, and lack of bed bounce like the competition has... I’m still torn on leveling up or down because I may go off road, but I’m limited on up due to the dumb Sirius antenna hitting...
  10. A

    To level up, or level down...

    I just leased a 2019 ram Laramie black with the factory 22s, and I hate the rake... unfortunately I really don’t want to spend $1800 on tires to make it look proper if I leveled the front up 2 inches, so I was debating just dropping the rear 2 inches. Does anyone have photos of either done on...
  11. A

    2019 Limited review: bought at a dealer 800 miles away

    Good thing you went there and not larry Miller (the other two dodge dealers in abq). I went to Tucson to get mine after a poor experience with larry Miller, and didn’t have the model I wanted at Melloy. I will be using them for service, so if I get another dodge, maybe they will earn my...
  12. A

    MPG effect of 3.92 rear end

    Couple ways to look at this, as driving conditions and style will affect the outcome either way. On a completely flat surface at a steady speed, say 75 mph, comparing two identical trucks, with the only difference being gear ratio, the lower gear will get better fuel economy as the engine is...
  13. A

    What tools are in your truck washing cabinet?

    I have a pressure washer, various quick detail sprays and things for touch up, then for hard core its a Dewalt variable speed buffer and 3M products for waxes and brushes. Ive used them on my prior BMWs and lighter colored cars, but since this truck is black, and I dont have experience with the...
  14. A

    Recommendation for ReadyLift installer in Chandler, AZ (or surrounding area)

    My buddy Rob has a shop in North Phoenix that specializes in Jeep and Dodge, and he has a new Ram as well. Give him a shout, he does amazing work and has a gorgeous shop. AZ Offroad & Performance, 2340 W Parkside Lane, Ste H112, Phoenix 85027
  15. A

    Newbie with a new Ram!

    Long time dodge hater (had a 2006 srt-8 when they first came out that had some growing pains), but after seeing the 2019 rams, I had to get one! Picked up a new 2019 Ram Laramie Black yesterday... just the important stuff like Harmon Kardon, 12 inch screen, 3.92s with traction diff etc!
Back
Top