Search results

Linky to Resistor

Yes, I used the Metra 72-7902. The black wire is the negative, has the small connector that fits on the small spade of the speaker. somewhere around this forum is a diagram of the base 6 non amplified system. I'll see if I can find it. The reason for the resistor, and I tried without it. The...

Dealer knows nothing and also mopar recalls site knows nothing

I did 2 sets of the 9632 coax speakers front and rear, and 3032 in the dash. Ended up putting a 4 ohm resistor in line with the front dash speakers because they overpowered everything else, the stock fronts are 8 ohm. with the 3 ohm fronts and without the resistor I measured around a 1 ohm...

I got my mailed notice over the holiday weekend. Called my Ram dealer and they have no info. They only had the tailgate adjustment recall but I don't need them to mess with that one. Checked my VIN on recalls.mopar.com and again the only recall they show is for my tailgate. So 2 months in...

I did grease them after install. excuse the mud. this is with the Bilsteins and I ended up with a 3" lift. Ranchos actually gives recommended alignment specs in their instructions. I gave the specs to my alignment guy and he aligned them to that. I have zero issues with alignment or...

Installing the Kicker this weekend and if I have time I have a JBL amp for the sub on the Jeep.

There is a lot of information about cab leaks around the rear window (the frame will crack) the shark fin antenna, and the 3rd brake light. Water will run down the inside of the cab behind the rear seat where the rf hub (for the fob) and also the battery for e torque if you have it. I...

I WANT o_O

Want to brag on lasfit for a bit. Had a little troiuble with occasional hyperflashing on the turns and they jumped up and sent another set, even thought the set I had was a promo freebie. The hyperflash was on the dash and also briefly showed a light out display. When I had this fault I went...

Regeared a Jeep and when I got it back had a vibration. Told the shop guy, who had a really good rep, that something was off on the setup and he told me impossible. He went through a bunch of stuff checking, then built me a custom driveline for 5 or $600. Still no good. I told him maybe one...

I thought perhaps water got inside the flares and rusted from the outside in. It would be easy enough to keep the wheel wells clean

I'm afraid to put flares on mine. My '09 had them and I took them off to replace busted manifold studs and they were full of rust under the flares

Amusing, The Jks all had this issue, I thought they put a gasket between door and hinge in 2016 or so to stop it

I did a perforated rear window graphic

Definitely bowed, is it seated properly at the top? Do both look the same?

I was >< close to getting an audiocontrol amp and I think the accubass system would add substantially to the sound because this factory head unit seems to want to drop off the bass when played at higher levels. With the factory system when I would play at louder levels it also seemed the volume...

In the base 6 speaker system the doors and the dash are basically component speakers on the same channel. Connected together and ohmed out from the plug at the ANC I read aprox 2 ohms. I ended up using the Infinitys all the way around and installed 4ohm resisters inline on the positive side of...

They are popular, I wonder why there is no flat to put a wrench on the tube side, or on the threaded end. Seems like you would be tightening the locknut against the duraflex bushing. I like to set the length and then torque it down on a bench or vise

On my Jeep I mounted above the rear view mirror, up out of the way