Search results

Just want to chime in here and post my results with changing the Special Vehicle Config setting. I have tested multiple themes, and they have all stuck so far. Granted that it has only been through several ignition cycles. I currently have it set to Sport. The only thing I have been doing...

My dirt bike riding days are some of my best. Nothing like it. Sent from my iPhone using Tapatalk

It’s great. Would like to see a diagram with all the wires, connector names/numbers and connection points. This would make this a DYI for anyone willing to do the wiring. I may try to figure that all out soon. I want to get the 360 camera retrofit done first. Sent from my iPhone using Tapatalk

Last weekend I traded some items for these wheels. This weekend I had the tires swapped. These tires are not my final choice, just picked them up cheap. I plan on putting Baja Boss tires on in the near future. Tires are 305/55R20. So 33x12. I may keep this size or go to 12.50. Zero rubbing on...

https://www.ebay.com/itm/305463928096 I bought the dark gray in 50x149cm. Still had some leftover. Sent from my iPhone using Tapatalk

I replaced my original bezel with a TRX version, to match the TRX interior swap I have been doing. The TRX bezel was used and had a hole in that cubby, that was drilled by the previous owner. I used that hole to mount and solder a USB connection. I then put a MagSafe charger on top of the bezel...

Thanks. It is even better in person. It was a thirty something dollar experiment. I was fully prepared to remove it if I didn’t like it. Sent from my iPhone using Tapatalk

A195 is Pin 25 in: ASSEMBLY-POWER DISTRIBUTION CENTER-INTERIOR C1 Where is this connector located?

A195 is Fuse 42, here is what I found for fuse 42: 42A&B 10A Mod Transfer Case Switch Module (TCSM) / SBW / Electric Park Brake SW / Module TPM Trailer / Module Gateway Can-C Trailer TPM / Seat LT & RT Vent

That wire is probably a lower gauge(thicker) than you might think. Sent from my iPhone using Tapatalk

Well that is progress Sent from my iPhone using Tapatalk

That setting should be programmed or not programmed. Mine is defaulted to not programmed Sent from my iPhone using Tapatalk

Also, I bet if you disable the debugging setting for the turn signals, or set them to LED, it would stop them from getting disabled.

Well, I had LEDs from the factory. So I did not have to wire anything extra. However, I am sure there is a way to get them working properly. I had a 22 Jeep Gladiator and I added some aftermarket headlights with signature lighting. I was able to determine the signature lighting circuit in the...

Far better than the reflector LEDs, but the Limited/Longhorn are still better than these. I previously owned a '20 Longhorn, so I have used both. My original plan was to do a Limited/Longhorn front end swap, but the deal on these lights was too good to pass up. These are a good alternative at...

Here is how it looks with DRL set to turn signals:

The install wasn’t all that bad. Getting the lower trim panels off was the most aggravating. I managed to do it without breaking tabs. I followed the aiming procedure from Morimoto and the output is excellent. Far superior to the reflector LEDs. The signature lights are very bright, especially...

Thanks. I tried out a vinyl wrap that looked like wood first, but it just didn’t look right with the contours of these pieces. I am happy with the way the suede turned out.

I bought the dark gray because the black would have been too dark. The dark gray could be darker, but I like the contrast against the dash color.

Have you tried placing your phone on top of the dash? Seems most likely that your phone is not getting a strong GPS signal.