Search results

Not yet

Definitely be a new thread (there actually needs to be an entire new 2025+ section), very different install.

According to the parts catalogs, yes. It’s on the driver side of the transmission:

Wrong forum?

I see the setting there in demo mode: Choose Ram 2019-2024 DT > Modules > Body Controller > Configuration > search “seats a”

That person had an issue that was unrelated to the recall.

It’s not a physical part. It’s a software flash to the ABS module. It does not need to be driven at all for the recall flash.

The equipment listing is no longer available via that link. The parts department can still get you the actual build sheet, but not sure how long after the truck is built it becomes available.

Make sure you set VehConfig 1: Model Year to 2022. Double check Radio & Connectivity: Digital Rear View Camera Present and make sure it is set to yes. Reboot the radio twice.

Not sure what else you have going on. That’s definitely the setting that makes the grid lines work again (assuming you turned them back on in the radio settings).

They’re not available anymore at all starting for 2025’s.

They are two completely different camera systems. Your mirror is the dual camera mirror (it’s been around since 2022 HD Rams). There are two inputs on the back of the mirror- one that goes to the camera in the the third brake light, and one that goes to the single port on the bumper (the tow...

If heated seats turn off by themselves, there’s an issue.

No fuses at all for the trailer light circuits on the 25’s. They are all controlled by the trailer tow module now.

For 2019-2024 F12 is for the trailer park lamp circuit. On the 2025’s, F12 is for the front left headlamp module.

Should be all the info you need in the following thread: https://5thgenrams.com/community/threads/no-tailgate-ajar-warning-my22.38541/

No, the dealership can not turn it on. You can do it with alfaobd or JScan. All 2019-2021 trucks just need alfaobd or JScan to enable the warning. All 2022-2024 trucks that came from the factory without the warning need alfaobd or JScan to enable it, AND need the correct passenger tailgate...

Try running the abs initialization procedures. All info on that is in the following thread: https://5thgenrams.com/community/threads/how-to-add-adaptive-cruise-control-lane-assist-fcw-auto-hi-beam-to-ram-1500.30924/

Most of the work is done through the wheel well (easiest to remove the liner, but not necessary), and through the top of engine bay. Really, the only thing I do from underneath is pull the wire harness tree off the bracket, and the last bolt off the bracket to pull the module out from...

Try doing a factory reset, don’t set up any profiles, then try reinstalling the map update.