Search results

Hello, comrades! There can be no values of 0/0/0/0. After changing the settings, you need to perform the "height sensor check" item, otherwise the truck will get stuck in random or factory mode. Here are the values of the factory front axle 100+/- 12mm, rear axle 68+/- 12mm. For normal operation...

I installed a grille from the diesel version, I plan to install a led bar

Installed the update - the noise during braking stopped

To install the cargo compartment cover and not to lose its design feature. Most covers are not compatible with MFT. I rode pickup trucks and watched the body panels crack, I was very happy with the brackets that were installed by the manufacturer, but I need to install the cover.

There are a lot of American cars in Russia, we love them!

Friend, I live in Russia, delivery will be expensive. I can share the drawings when I'm done with them.

You're almost at the goal! Factory exact values do not exist, they are individual for each truck, but you can reduce the values until you achieve the desired result, for example, write 90 for the front axle. After your truck remains at the right height, you need to check the height sensor. After...

Today I made brackets to replace the factory ones. Those plates that sell don't work, I'm an engineer and I'm telling you exactly that. Do not pay attention to the protruding part, it will be bent and an arc will stand on it.

Write down the factory values to start 110 front axle and 70 rear axle. Increasing the value you raise and vice versa, if you reduce it, you lower it. When you are satisfied with the result, perform the procedure to check the height sensor

Yes, you're right. In practice, I didn't notice the poor operation of the suspension. For maximum comfort, the lower lever should be as horizontal as possible to eliminate transverse resistance. But this is possible only with serious interventions. I like the kit when the attachment points of...

Hi! After setting the suspension height, do not forget to check the height sensor to record the values.

It's very simple! In the suspension menu, you need the item "set the height of the suspension". Here are the factory parameters - front axle 108+/12, rear axle 68+/-12. I set the values 130 left front 109 right front, 58 left rear 50 right rear. This made it possible to raise the front part and...

I had a similar problem. It is important to disable AAD and erase the fault code. The fact is that AGS and AAD have a common CAN bus. If you disable AAD, autorun will work and the MIL indicator will not be active. AAD was flooded with water, so I removed this element.

It's very cold in my city and I can't refuel my truck again. But I showed ingenuity - I refuel the truck after a long trip, when the return fuel entering the tank heats its contents👍🏼

The problem can be solved with alpha obd in minutes. I also raised the front part and lowered the back so that the truck was parallel to the road surface.

Greetings to everyone! Electric running boards were installed on my truck, I installed running boards from TRX, pneumatic suspension reports error u0422, I read from an FCA document that the air suspension has a connection with running boards. Are there any ways to turn off the survey on the...

Turn it on with alphaobd, then in addition to the red icon, there will be a message for the entire screen size

It's strange. On my truck, you can only open the back door in parking mode

I'm driving a maxxis razr at lt 285/50/20- an excellent tire. Quiet on the asphalt and productive on the mud.

Thank you, buddy!