Search results

Just ordered everything. Is it pretty self explanatory to mount? I’m assuming I pull trim piece from location, replace with new trim piece that allows for light mount. Screws go into light, screws then go into nut and they attach to the new trim piece? Are my assumptions pretty close?

Appreciate the info!! I’ll be looking further into this for sure.

Ahh didn’t know about a plastic mount! Any part number by chance? I was just going to hard wire it instead of messing with harnesses. Did you have to drill holes to mount?

Looking to see if anyone has installed the 3500/TRX rear center marker lights on their 1500? Part number 68362184AB Plan to wire into trailer harness adapter that I got for my reverse pods. Curious if anyone knows if it’s a direct mount or if I will have to drill holes? I’ve seen talk about...

Did my take on what I wanted for reverse lights using various methods found on here. Used the referenced Curt adapters. Wired to reverse lights and on a switch wired to constant power. Wired in bed lights as well, all feed to the trailer wire harness. Used 3.5 inch pods mounted on tubular...

Grille arrived. Mesh is color matched to truck.

Thank you! Unfortunately no clips to align, just 3M. Can always use masking tape to mask off points of the old emblem before removing.

Just received my emblem from Billet Badges! Super excited to see how it came out! The custom upper and lower grille and emblem I purchased from Royalty Core will be here Friday. Hoping to install on Christmas. Will be selling the factory Chrome Laramie grille if anyone is interested! Moving...

I am so thankful you brought this up as it lead to me looking at the instructions. Lol I attached a screenshot. Looks like I’ll be calling the shop tomorrow and asking for a driveshaft replacement and asking them to finish the job!!

A recent noise has came about and it was found that the front driveshaft is rubbing on a plastic guard for a cable. Trouble is, I don’t see how or why this has suddenly become a problem. I did just lift the truck 6 inches, however, I don’t see how this would have changed anything to put the...

Thank you for your response!

Alright, so after reading through all 67 pages and 3 days later… lol I first picked up the parts to do the hack, then came across the TSBs on here. Just spoke with my dealer, truck is at 41k miles and I do not have an extended warranty. Dealer says TSBs are not covered outside of warranty...

Much better than basic 6 inch strut lift. I expected a lil better, however, realistically they are 37s lol. Might have seen that with a softer 35. I am happy with it though! Really absorbs large bumps well, speed bumps are night and day.

How did your project turn out?

Selling old mirrors if interested! In the FS section!

Truck is now sitting on a 6inch Rough Country Vertex coilover system on all 4 corners. 22s and 37/1250s with 1.5 inch wheel spacers to allow clearance on the knuckle. Shop also put on amp steps. Also tinted taillights and 3rd brake light, added bed step, replaced dash speakers with the...

You’ll be good. I had a 20x10 -24 on a 35/1250 just leveled on bilsteins. Worse case you trim some lower valance and inner liner but highly doubt it.

22x what? A 22x10 will work with little to no rub. A 22x12 will require a 33 or more lift.

Best website to order quality wheel spacers with quick delivery? Needs spacers to fit my 37x12.50s and was an oversight by me and am now in need of them in a hurry. Thinking of just doing 3/4 inch. Current wheel is a 22x9.5 +15. Barley clear the 285/55s I have on there now. What would...

Lifting my truck this week and will be pulling my ORP front springs out if you are interested in buying a slightly used set.