5thGenRams Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Recent content by Walski

  1. Walski

    New member here, NW AR

    Beautiful build..I need some pods like that. Did you make them?
  2. Walski

    Replacing 5" UConnect Head Unit

    I flashed it for the 2019. If you go to the website they have it listed. They do not make an intergration piece for the factory camera yet
  3. Walski

    Replacing 5" UConnect Head Unit

    I replaced mine with a kenwood excelon 706s using the i data rr. I used the best kits dash kit from the 4th gen. The only thing you don’t retain at the moment is the factory back up cam and the USB ports. So I mounted a usb in the trim panel with my bass knob. A full depth head unit might give...
  4. Walski

    Amp Install Locations

    Back wall
  5. Walski

    Remove rear seat backs?

    I grounded to the same point as the etorque
  6. Walski

    5” system aftermarket upgrade

    There is still no way to integrate the factory back up camera with an aftermarket headunit
  7. Walski

    5 Inch to 8.4 Inch Upgrade

    Had to use the dash kit from a 4th gen
  8. Walski

    5 Inch to 8.4 Inch Upgrade

    I went the aftermarket route.
  9. Walski

    5th Gen Stock Stereo Upgrade Options?

    The whole bezel pops off after you remove the to screws in top under the little piece of rubber then I trimmed behind that sction with a dremmel
  10. Walski

    My complete 6 speaker upgrade

    Finally close to being done with my system upgrade. Jl c2 6x9 in doors Jl c2 3.5 in dash Kenwood excelon dmx706s headunit Maestro rr and harness Stinger 8000 series rca cables Jl 400/4 amp for miss and highs Sundown sa 12” subs Sundown sae 2000.1 amp for subs Fox box Pac audio dash kit for...
  11. Walski

    5th Gen Stock Stereo Upgrade Options?

    Hopefully finish my 6 speaker upgrade this weekend.
  12. Walski

    5th Gen Stock Stereo Upgrade Options?

    Pac just updated the amppro to work with non amplified systems. I would go this route but I have everything to replace my 5” radio this weekend with an aftermarket kenwood
Top