Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Just because I'm still running them, doesn't mean I'm too confident in them. I've had the wheels on and off probably 10 times and they don't show any signs of fatigue, something about $30 lug nuts bother me though. They've been on my list to replace!
ZY Wheel 14mm x 1.5 Thread Size 51mm Long...
Apologies for leaving this critical piece of info out! They have to be placed on the outboard edge of the wheel otherwise they'll make contact with the caliper.
I found this out after I brought the wheels and tires home and mounted them. I removed any weights that were mounted on the inboard...
I'll try to provide some insight here! I know how the search for the right tires and suspension goes!
The first truck is mine with 295/70R18's (34.3 x 11.6) on fuel shok 18x9 (-12). I have bilstein 5100s on the 6th position (2.2" of lift). There is a slight rub that I hear only once a week...
No worries! It looks great, love the color too! I've always had gunmetal / gray vehicles -- you can never go wrong with it! I sure do wish my truck was as clean as yours too.
I wish I had compared the stock with the Mopar UCAs. From prior reading, the Mopar UCAs just allow for more articulation of the ball joint, they don't necessarily change the angle. Somebody feel free to correct me if this is incorrect. This may explain your angle observation!
This is an overdue...
They have a +19 offset.
Here are -12 offsets with 295/65R18 tires for reference. Also check out the below link. It's pretty helpful for getting the look your after while juggling offset and different tire sizes.
https://tiresize.com/wheel-offset-calculator/
I'm sure this covered somewhere on here but I can't find anything definitive. Are there any .5" or .75" rear coil spacers out there? I see them for the previous generation truck, just want to make sure they will work for the new body style. These will be used with Tuftruck 1223VT rear lift...
I did not. Right now it's simply 5100's up front and the spring spacers on the rear. I wanted to get a good idea of the stance before going full bore into all of the suspension components on the wish list.
That being said, I seemed to only have realized 1" to 1-1/8" in the rear. I'm fine with...
I was / am planning on doing it myself. If it turns out terribly, I'll just take it to someone and have them do it. I always like to try something once though! You do bring up a good point and likely are on the same track I was about the mirrors. I think your message was all I needed to get...
I've done some looking but cant seem to find exactly what I'm looking for. Is there any place that color matches vinyl? I'd like to closely match my wheels but haven't found something close enough (I'd rather be spot on or use a completely different complementary color). I'm still undecided on...
Finally found some time to get everything installed.. Bilstein 5100s set to position 6 (2.2") and 1.5" motofab spacers in the rear. Couldn't be happier with it! (Apologies for the dirty truck this time!)
I'll very likely be swapping the rear spacers for some Tuftruck 1223VT springs which should...
Thanks Richard.
Initially I did try all of my impact guns. That didn't do it for me.
I've not seen the chisel nut split solution before. Let's hope I never have to try it! Awesome to know though.
Here's what I did do though. 60v Dewalt reciprocating saw + 5 blades through the shaft. I was...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.