Recent content by spinxt

Why would RAM do that? So dumb.

I recently removed the Fox shocks that came with the Mopar 2" lift and replaced them with Bilstein 6112s in the front and 5100s in the back. I now have a bit of rake to the stance (lower in the front). I have the 6112s set to position 8 (the highest they can go). If I removed the rear...

I have not. I'll try that. I did disconnect the pink connector at the camera and clean it. It helped, but it still periodically goes out.

I'm having an issue with my backup camera and replaced it with a brand new (OE) one. I'm still experiencing flickering/ occasional outages. I'm now convinced it's the cable. I'm struggling to figure out what the part number is for a new cable (2019 Laramie). My local dealer has been...

Does anyone have any recommendations for a scan tool that can clear codes behind the Security Gateway Module (SGW)? I've been looking at the Autel MaxiCOM MK808BT Pro. Their website states the following, however I'm trying to confirm if it can actual CLEAR codes behind the gateway or just...

I have the RBP Stealth Power running boards for my 19' RAM. I just snapped one of the brackets (for the second time). I don't know what the deal is. They have a weight rating near 300lbs and I weigh 192lbs. There's no way these things should be snapping. They took care of me the first...

UPDATE: I called my dealer's service manager last week and expressed my frustration pretty directly. Miraculously after a 7 month wait, the manifold showed up two days later. They are available, they are just on allocation (meaning they can only oder one every week or so). If you don't...

when the leak/ broken bolts were detected I was under maxcare. My maxcare has since expired, however I’ve been assured since it was logged before it expired its still covered. My fear js the longer this drags on, the chances go down each day that passes.

My 19' RAM needs it's second exhaust manifold replacement due to warpage/ broken bolts. It was diagnosed in September (2024). It's now almost February and the dealer claims it's still on back order (passenger side). I'm normally a pretty patient person, but the tapping sounds upon startup...

My 5.7L Laramie has developed a whirring gear noise in the front drive training. I have tried the following: -changed both diff fluid -changed transfer case fluid -replaced rotors/pads - replaced front hub/bearing assy's It seems do def be coming from the font axle assembly somewhere. It's...

I thought the same, however that doesn’t explain why the sound goes way (or as at least way less prominent) when just cruising (without power applied). I would think if it was a CV joint or wheel bearing that the sound would be present as long as the wheels are spinning

I'm at about 95,000 miles and it's time to replace the brakes on my 1500 Laramie. What is everyone using for replacement brakes? Stock? Aftermarket? I recently put PowerStop heavy duty slotted/drilled rotors and pads on my Grand Cherokee and they are crazy noisy. They click like crazy to...

You'll never hear it through phone recording.

Lately, I've developed a whiiring/whooshing sound audible between 20-60mph (Pretty sure it's still there above 60, however the wind noise drowns it out). At first I thought it was just tire noise, however I have fairly new KO2s and only seem to hear this sound from the right side (I can't...

What do you mean hard to research? There are TONS of threads on this forum about the Borla cat back options. I’m unsure how you were surprised the s-type is loud. It’s well documented that the atak and s type are loud. At any rate, I’m glad you found a solution you are happy with. I’m...