Recent content by RebelJC

So will the tires I have now still fit?? 285/75

Probably use this one.

Nothing brewing right now, but in tap Yellow rose IPA clone (left) Light blonde (middle) Island mist sangria ( right, put your island mist kits on tap to carbonate and you'll never bottle again)

Here are the pics you requested. Sorry it took a while.

I will get those pics soon. I figured there would be a compromise, I just want to minimize wear if I can. I may take out the 3.5" in the front and replace with a 2" and leave the rear 2" where it is. That should give me a better angle in the front and still be 1" taller to be level.

Suggestions to help my CV angle?

I definitely have a more stiff front suspension. Drop a clip? Something I can do??

No, I rented a spring compressor and did it in my driveway. I will definitely take into consideration the CV shafts. I never thought it was going to be an issue.

They came with double sided tape and wiring kit. I tapped into the marker light.

I have the same MBRP. ZERO drone unless the MDS kicks in. Sounds great and easy install.

https://www.americantrucks.com/motofab-3-front-2-rear-leveling-kit-0918-4wd-ram-1500-excluding-mega-cab.html

https://www.carlightingdistrict.com/products/3-pod-led-grill-light

Here are some pics after alignment.

FYI, to all interested. Offroad RAM models installing 3" motofab spacer you MUST use spring compressors. There is a different angle than a standard 1500 (according to the motofab paperwork)

No. 5.7