Recent content by My_first_RAM

My bushwackers fit.

Foam cannon and power washer, then wipe down the windows. If it gets super dirty, then I will use a soft bristle foaming brush. Whole lot easier to keep looking clean and streak free compared to that RAM black that shows EVERYTHING!

They basically take the entire truck apart and even remove the bed. Every bumper component is disassembled and sprayed. It’s a 3-4 week job if they do it right and it isn’t cheap. It’s similar in texture to a bed liner, but it’s actual Kevlar fibers in the paint. A little extra protection and...

No going back now. That Kevlar coating isn’t coming off. LOL

Got the truck Kevlar coated.

Lots of changes in the last year and a half. I really enjoy this truck build and I dig the Kevlar coating!

I am about to go from 33s to 35s and looking at calibration options. On my jeep I used the flashcal and I wanted to get some recommendations. Let me know what you guys are using and what additional options are out there…anything beneficial outside of calibrating tire size. Thanks.

I’m in a 2020rebel with the fox coils set at 3”. I have 20x12 -51 offset with 33x12.50 and I only rub when I’m at full lock on an incline or decline…basically when I maneuver up my narrow driveway. I trimmed that little tab off and zip tied the liner back. You should be about the same since that...

I have been searching around on whether or not there is a way to use the fox 2.5 res shocks with a BDS 6” lift. Everything I can find says I have to go with the fox 2.0, but I hate having to downgrade from the 2.5s that I currently have. If anyone has any idea I this could possibly work, let me...

Go Rhino RB20 I believe

If you are at 3”, replace your UCAs immediately! Shocks will help the ride, but you are putting a ton of stress on your UCA ball joints.

Has anyone noticed a really loud pop sound from their exhaust during startup? It’s not all the time and I can’t figure out when or why it’s happening. I have a flowfx muffler and resonator delete, but it did it when everything was stock. Every once in a while it’s super loud and my wife even...

Hey guys, looking for some help here. I was under my Rebel tightening a few things and I noticed that I have wear on the knuckles and lower control arms. I have the coils set at 3” (2” above stock Rebel ride height) and I’m really shocked to see this kind of wear. Have any of you seen this or...

Thanks guys. I had my dealer do all the work and they are truck guys. Great team over there. They did some work on my JKU as well. I’ll take it over there and throw it on the lift and have them go over everything.

I have a good CM of gap. LOL. They are power actuated, so I can always fold them down. I had to remove the thick weather strip and then I put a thinner version. The driveway slopes down and there is a small drop at the door. Currently getting quotes to reframe the garage opening and another door...