Recent content by joemo

I found a guide on youtube and I think its fixed. I tested on a normal drive but not a parking lot yet. Anyway, I took the front mudguard off, trimmed like 2 inches of the plastic that goes into the little bracket (that plastic fastener goes into) and then I bent the bracket up. I did hit...

Been awhile since I posted. I have a 2020 Ram 1500. It was not new when purchased. It had 33in tires on it but the other day I was out and knew that at some point I would need new tires and figured I would stop into the tire place. fast forward, I walked out with Toyo Open Country A/T III's...

Thanks!

I removed it because after the new bumper, you could clearly see it hanging there. Just looked really strange.

I have a 2 hour drive today and will be doing highway miles at about 75. It will be a good test and will report back. I have been on the highway since removing but never noticed. I will turn the radio down even to see if I hear/feel anything.

Nope, nothing to report. Gas milage is the same 14.1 mpg. Handling is fine, and no errors :) I just listed my airdam even since there have been no issues.

Thanks, I was on the fence.. I will run the actual switch to turn it off/on into the cab.. It will be done correctly atleast.

Tap power. Basically, when I put high beams on, the light bar will come on. I hardly use high's but when I do, it would be nice for the bar.

2020 Ram Big Horn Has anyone done this? I tried to tap into wires that go into the high beams but that did not work. Can I tap into any of these wires? This is in front of the drivers side wheel. thanks

big horn fogs.. I plan on posting my 2020 big horn fog lights in a few days. I am in florida so dealing with this hurricane. I took the entire bumper off since I replaced the bumper. You can see my before/after in you look at my posts.. thanks Joe

So far, It is just disconnected. I have the entire dam sitting with the front bumper. No CELs yet.. but I have a decent drive tomorrow... so fingers crossed.

That is easy solution.. Add them to the arm rest on the back doors. You can tap right into the window switch. Took me about 1.5 hours to do both doors. Screenshots attached.

Ok, next update. Painted the ram letters, hooked up the led fog lights to the stock harness, marker lights and removed the air dam. Big lightbar is next.. I need to get all this stuff up for sale soon too.. lol

Nope. I just toss a few things down there. Nothing to really organize.

Here you go.. This is what it looks like.. Hopefully nothing offends you. The organizer is nicely made. You do need to take the rubber insert out of this area if you have it. It will not fit with that rubber piece.