Recent content by Fartknocker

Where did you ground the amps back there? I dont have the etorque but i have a bare bolt sticking up in the middle of that bubble tunnel of carpet where the etorque leads come out of yours. I was thinking this must be the factory ground for the etorque? Or is there a better ground under there...

I used the bolt right under the alternator case and added another 4awg to the stock frame mount. Both blue arrows in the pick. Im running about 2000 watts to subwoofers and door speakers with 2 amplifiers. I have no voltage drops even at max volume since i did the big 3

Has anyone run new speaker wire into the front doors. I wanted to put some new component speakers in the door and use the dash location for tweeters. After a quick look in the door jam and under the dash this seems like quite the task. If anyone has done it and could offer some tips I will...

2019 big horn. Base non amplified system. Looking for a good ground for an aftermarket amp under the driver seat.

I am going to be installing an audiocontrol dq-61 into a 2019 8.4 uconnect nonamplified base stereo system. Adding a 4 channel and sub amp. My main question is do i need to wire in some sort of resistor to mimic speaker load since i am cutting the factory wires and putting a dsp inline? Does...

I was going to help a friend install a subwoofer and amp in his 2019 big horn v6 with the base non amplified system. I have a 2019 big horn 5.7 and i had to buy a bypass harness for the anc to install an amp. Does he need a similar bypass and/or does the v6 even have an anc system?

You still do have to splice into the speaker wires on the harness for the LOC but you can do it easily outside the car and just plug it in. And can be easily unplugged and the truck.is back to stock in a minute

No im pretty sure the ANC is disabled though i have not noticed a single difference in cabin noise. Everything is as quiet as it was, no extra engine noise that ive heard about other harnesses. The part number is PAC ANC-CH01. It just became available a few weeks ago im told. I had one of...

I just got the new pac anc ch01 harness. Its plug and play and is labeled to wire a loc to the harness. No cutting or splicing factory wires. Took me 10 minutes to hook up an lc2i and run the rcas.

I put 2 sundown 8" sd3s under my rear seat in a 1ft3 sealed box. The 10" version also does well in a .5 ft3 enclosure. Im blown away at how these sound. They are sundowns shallow mount option although they arent super shallow at about 4.5". Ive had a lot of different stuff in the past and...

I know not exactly what younare looking for but i have Tyger star armor bats on my truck. Better than most and you dont see em.everywhere

Thank you. One more question...I have the wiring schematics for the factory anc/amp. When wiring in the sub is it preferred to tap into the rear speaker inputs into the amp or the outputs? Im assuming ill use the rear door speakers for a signal but i see both rear speaker inputs labeled as...

So this harness plugs into the anc amp under the driver seat? If im only adding a sub do i then have to wire the factory speakers back in? Or does everything work fine just plugging it in and i have EXTRA speaker leads to wire in an lc2i? In addition to bypassing the anc?