Recent content by Encswsm

I Went out and looked at it and yep thats what it was all three were missing. Plus the guy broke the right side tabs on the upper cover... Frigging ***&*le.. I’m calling tomorrow and making them replace it. Thanks

Thanks I’ll check that out

So today I had my windshield replaced as mine had a crack after being hit by a rock. After it was replaced and the technician left I found 3 small rubber buttons. One on the ground and 2 in the passenger seat. Does anyone know what they are. Am I going to be miserable with rattles and bumps now?

Here you go. Just drill some holes and attach one of these

I would use the Trailer plug in the back of your truck. on a 4 pin connector it would be the outside 2 pins furthest away f4rom the Plastic piece and on a 7 pin its pin number 5 the blue one.

Do you think if I pinned in a different light system into the pin locations you used for your MOPAR light system they would work like the MOPAR lights

Do you think that using your Flash free diagram I could add lights that are not MOPAR factory lights? Also where does the one wire you un-pin go to?

I wonder if this pinout would work for a different set of lights?

Here is the part number for the black one 5YM59TX7AD

I think this page has what your looking for. https://www.moparpartssurplus.com/a/Ram_2019_1500-LARAMIE-CREW-CAB-57L-HEMI-V8-4WD/_55066_7562305/Load-Floor-Cargo-Rear-Underseat-Compartment-Storage/i2384183.html

I want to know why there's any coolant flow when the AC is on? Seems like the 3 way electric valves on the 18 and older is the solution.