Recent content by billybaloneey

For the front grill and driver side mirror camera cables I just used a extra long (24") semi rigid cable tie (Harbor Freight has them in packs of 5 I think), and just poked around behind the radio, about where the bottom of the dash ends, (I did not move or remove the center console), till I...

Firmware version is T27.46. I removed my telematics box a while back...6+ months ago, I think.... so I've not had any over the air Uconnect updates recently, that might be the cause of any screen issues. I had errands to run this morning...it was cool...only about 60F...so that made me think...

I have a 2022 RAM 1500 Lone Star with a 12" Uconnect 5 screen. Just recently a couple of issues have started occuring: 1) On multi stop trips...after turning the ignition off then on a little later...the screen is blank...but the last music source used will function sound wise...doing a hard...

The LED light is easy to move from one handle to the other...if no one replies with a part number.

I did a DIY bed camera...I have a 2022 RAM 1500 Lone Star...a while back I added the 360 Surround camera system, (the thread on how to do it is on the forum)...my understanding was I could not add a bed camera with the 360 camera system in place, so I looked for an alternate way. I bought a...

I did it...it is a pain...you have to virtually disassemble the whole mirror to snake the Fakra cable. I used a large rigid zip tie as a fish tape...you'll pull a little, then adjust/move the existing cable bundle, then repeat the process several times till the Fakra connector is pulled through.

Mystery solved...I did have that door lock setting enabled...it is now disabled and everything is working as it should...thanks for the tip.

I need some trouble shooting advice. I have installed the passive entry on all 4 doors of my 2022 RAM 1500 Lone Star, all the doors function properly except the driver rear. Touching/grabbing the driver rear door handle will not unlock the door, but it will unlock the driver front...and that...

You can contact KSPIV through Amazon...they will send you an update file.

The battery isolator connects directly to the main start battery and the second battery...there are no connections elsewhere. I suggest you go to the Redarc web site...and send/ask your question...their isolator is designed and built in Australia, (they have distributors worldwide...USA), they...

Even before I removed the telematics box in my truck...and when I occasionally had the performance pages and the off road pages, the location and altitude values at the bottom of the page were not correct...after removing the telematics box the off road page location and altitude are still...

If you will message me your mailing address...I will send you the camera bracket so you can try doing a 3D printing of it...but I would want you to return my original...and if you make $1,000,000 from duplicating them...cut me in for 10%.

I think there are a few used mirrors with cameras on eBay...in the $250 range.

@Ramhighflyer I went out to the garage to take a look at one of the used mirrors I have, with a camera mounted in it, and took some pictures. The camera assembly has a bracket that the camera clips into...and the bracket has a notch and a screw attachment where the camera mounts into the...

The camera bracket is "NOT" inside of a mirror that is not OEM with a camera...it has to be bought...or canibalized from a used mirror that came with a camera.