Recent content by 2jzDave

I've seen the big thread regarding the 13.5" Phoenix Radio and I am looking at ordering one as my 8.4" Uconnect no longer plays music. The 11.5" has all the same specs minus the screen size. I haven't seen any pics of the 11.5 installed though and would like to see the difference compared to the...

Did you notice anything else happening when your pulley was doing this? Did replacing it stop the wobble? I just happened to notice mine doing essentially the same thing while looking over the motor while it was running and now I'm a little concerned. Truck has 116k on it.

I had a 1988 Supra with a built by me 2jz that I recently sold

I'll get back to you, I do think the poke is slightly excessive with the 1.5", but I may need to run these until I get 35x11.50s. I don't think a 1/4 inch will make much difference

What are you looking to get for them?

"Doing some quick math based on the reported 3/4" of clearance on a stock tire: 295 = .35" clearance 305 = .15" clearance 315 = tire contact with UCA 325 = tire contact with UCA"

I think it might still be close, I know there's another post about TRX wheels and someone gave a lot of info on how much gap there is to the control arm based on tire size.

I had to trim the fender liner/mud flap slightly. Still have a very tiny rub close to full lock, but I'll sort it out. Very happy with it. Ended up getting 1.5" spacers.

Yeah I'll have to see. I don't think it would be terrible, I have 0.25" spacers now so one more inch won't be too wild, they're barely past flush now. I don't want to trim the studs, I think 1.25" is the minimum without trimming.

Facebook marketplace impulse buy... $750!!! Going to need to get 1.25 spacers, like others have said, too close to the upper control arms. I plan on switching to a 35x11.5 which might clear, but these tires had a bit more tread left on them than I expected so I will probably just run them til...

Sorry for the late bump.... How is the drivability with the 3.21 axle? Do you know the weight of these tires? I'm looking at the new Falken wildpeak at4, 35x11.5r20 is ~64lbs per tire. My current 275/60r20 wildpeak at3 are 48lb per tire.

According to tire rack, the 275/60r20 is 3peak rated.

Just got my moderate muffler delivered today. Nice high quality piece with great welds. Installation was simple, I opted to remove the front hanger and rear hangers with bracket from the truck and swapping them to the new muffler off the truck. Seemed to work well for me instead of fighting...

I wish I could share with the class, but unfortunately my secrets pay the bills 😁

Don't believe everything you read on the internet 😉