abstraction
New Member
- Joined
- Nov 13, 2023
- Messages
- 4
- Reaction score
- 2
- Points
- 3
- Age
- 50
Hey all, new to the forum after recently receiving my amazing truck, and a happy Mark Dodge customer thanks to the advice here. Truck has been driving and towing great for 2500 miles until today.
I was re-setting-up my WD hitch today, and as instructed in the manual I left the ignition in ON mode (engine off) while adjusting the hitch in tire jack mode. It was probably on for 20-30 minutes. Lights should have been off, but audio was on. Truck was NOT connected to the trailer with the 7-pin.
When I got back in the truck to pull away, I found the ignition was off, and engine wouldn't even turn over. Battery voltage measured 11.6 with voltmeter. Charged it up a bit and got it started, but check engine light was on. Truck drove home ok, and got a variety of TCM communication error codes from OBD2 -- Google led me to a variety of wiring problems but nothing matching my story. Seems conceivable the codes could have been triggered by a drained battery rather than something more serious?
Does this ring any bells for anyone? Thanks!
I was re-setting-up my WD hitch today, and as instructed in the manual I left the ignition in ON mode (engine off) while adjusting the hitch in tire jack mode. It was probably on for 20-30 minutes. Lights should have been off, but audio was on. Truck was NOT connected to the trailer with the 7-pin.
When I got back in the truck to pull away, I found the ignition was off, and engine wouldn't even turn over. Battery voltage measured 11.6 with voltmeter. Charged it up a bit and got it started, but check engine light was on. Truck drove home ok, and got a variety of TCM communication error codes from OBD2 -- Google led me to a variety of wiring problems but nothing matching my story. Seems conceivable the codes could have been triggered by a drained battery rather than something more serious?
Does this ring any bells for anyone? Thanks!