won't save volume levels after update

[jws1982]

Returned from two 300 mile trips with stops/restarts.
I made point to set the VR, Phone ring and call volumes below 15 and saved it on the memory door buttons.
Each time, back up to 15, any above saved.
Text message comes and makes person jump.
Will have to live with it.......

I’ll test out saving higher volumes to see if they load on startup. I’ve always tried lower volumes.

 

[Hipster61]

Tried saving higher volumes (16-18) on all of the levels on the Media tab except the top volume (6).
Saved to my profile and key fob, went in and ate supper at a local establishment.
Each one was saved at the higher volume and the top one was still at 6. Will check again later today.

 

[Hipster61]

I’ve now found that the lowered volume levels do seem to be saved with the profile, but do not load properly on startup (revert to 15). After startup, if I then power-cycle the radio while the truck is running (hold volume button for 10-15 sec), the radio restarts and loads the saved volume levels too. I’d be curious to see if others can replicate this behavior. 2025 big horn.

Tried jws1982's method of a power cycle, lo and behold that worked! All volumes are as I saved them 5 hours ago.
I checked the volumes before the power cycle and all were at 15 or higher.
I will be repeating this to see if it's consistent.