Will Eibach pro lift stage 1 fit 35's?

[ericmc1220]

Hey Guys,
I know this has been answer probably 1,000 times. But I just purchased Method MR305 R20x9 +18mm offset with D Cepek 35x12.5 tires.

Will the Eibach Pro Lift Kit Stage 1 be high enough to accommodate this setup?

Also, Tire Rack currently has this for $917 in stock ready to order. Thoughts? Thanks guy, I appreciate it. I've been searching and calling around but figured this is the best place to ask. I should have asked sooner.

 

[db9]

Vertically yes, I think you'll have issues with so much positive offset.

 

[ericmc1220]

They were virtually the same offset at the stock rims? Overall they are 2.5" wider, so it's 1.25" on each side.
I measured and it looks like it will fit. Maybe slight modification to the plastic wheel well.

 

[db9]

Yes you'll be around 1.25" closer to the uca, etc. Your rim is essentially the same spec as stock. Almost every stock wheel I see running a 35x12.5 also runs a spacer, may clear but probably too close for comfort. There is the 1/4" spacer or you would need to jump to a 1.25 spacer. The lift will take care of the height fine. If the wheels and tires are mounted I would just do a mockup and put one on as is. Don't worry about inner plastic clearance, just pay attention to UCA and suspension components clearance. You could have a 10" lift or no fenders and still hit your uca's if your backspacing is not adequate.

 

[ericmc1220]

Thank you!!!
Instead of the spacer, could I get new UCA's that provide better clearance? Or would the spacer just be good enough?

 

[db9]

No the UCA will not get you any clearance, it just corrects the geometry/angles so that the ball joint isn't in a bind. I would suggest the Bora 1.25 spacer and you'll be good to go.

 

[ericmc1220]

Ok I gotcha. I was told the spacer isn't needed. Just looking for more help. That's all

 

[ericmc1220]

Dang I thought this would be an easy question for you guys. Bummer!

 

[Ram12375]

I do not think they would fit without spacers. On my truck with stock tires, I can't even fit my finger between tire and uca