Just installed the left wheel-well liner in my 19 Big Horn. Couple questions:
I need an additional 8 screws total with washers. Does anyone know part #? Watched a youtube video of a guy adding liners, but the screws he listed were not the correct ones.
Also, I broke the bottom rocker trim plastic push tabs. Anyone have the part # for this? I went straight gorilla on removing them, but if you're careful and pull straight down you could probably pop them out without snapping the plastic like I did.
Overall, they're pretty easy to install so if you have questions - let me know. You will need to reuse the furthest rearward trim plate with the new liners. It's a two piece section and I removed the front section just by pulling outwards and popping plastic rivots. The youtube video showed the drilling out the rivets, but like I said earlier... I went gorilla on this.
I need an additional 8 screws total with washers. Does anyone know part #? Watched a youtube video of a guy adding liners, but the screws he listed were not the correct ones.
Also, I broke the bottom rocker trim plastic push tabs. Anyone have the part # for this? I went straight gorilla on removing them, but if you're careful and pull straight down you could probably pop them out without snapping the plastic like I did.
Overall, they're pretty easy to install so if you have questions - let me know. You will need to reuse the furthest rearward trim plate with the new liners. It's a two piece section and I removed the front section just by pulling outwards and popping plastic rivots. The youtube video showed the drilling out the rivets, but like I said earlier... I went gorilla on this.