Tyger side steps! Crew cab

[Mikebighorn]

Anyone install the tyger side steps.
How do they look, I just got them delivered .
How was the install etc..

 

[JCLAWS1988]

Anyone install the tyger side steps.
How do they look, I just got them delivered .
How was the install etc..

I installed them, they are sweeeet. All black with 5inch width. Really enjoy them and the install was ok. People had said to use a wire brush to clean the paint off the thread of the screws....it did not work at all. I had to buy a die kit from hardware store and scored the thread which took a little bit because the screws were heavily covered with paint. After that it was a easy.

 

[Neurobit]

I installed them, they are sweeeet. All black with 5inch width. Really enjoy them and the install was ok. People had said to use a wire brush to clean the paint off the thread of the screws....it did not work at all. I had to buy a die kit from hardware store and scored the thread which took a little bit because the screws were heavily covered with paint. After that it was a easy.

 

[Mikebighorn]

Post pics of the running boards !!
Do you need a torque wrench ? Or just tighten as much as possible

 

[JCLAWS1988]

Post pics of the running boards !!
Do you need a torque wrench ? Or just tighten as much as possible

I used a die kit to get paint off screw threads and a torque wrench which worked great. I will post pictures here shortly on my next break.

 

[Klute]

Here are some pics of mine. I used a round wire brush that fits my drill to chase the threads. Mine are the 4 inch version.

 

[Cygnus A]

Anyone install the tyger side steps.
How do they look, I just got them delivered .
How was the install etc..

My favorite part about this post is you are asking these questions AFTER you already have them in hand.

 

[Mikebighorn]

My favorite part about this post is you are asking these questions AFTER you already have them in hand.

Facts lol

I recommend them lol

 

[Mikebighorn]

Tyger running boards looking fresh