SuspensionMAXX 3-3.5" End Links

[Taz.HD]

Have been trying to install these end links in my 2019, but cant seem to tighten them down without the bottow twisting out of control. I'm no mechanic and I dont play one on TV. Is there anything that would obviously cause this that I just overlooked?

 

[HSKR R/T]

Use another wrench to prevent them from spinning while tightening

 

[Taz.HD]

Use another wrench to prevent them from spinning while tightening

I didnt really see another place to put a wrench, but I did try putting a big screwdriver through the bottom

 

[Taz.HD]

When I tighten A, B (and A for that matter) twist with it.

Maybe I am just unclear how to install it. the video I saw, and the instructions just made it seem like you drop it in and just tighten the bolts to the sway bar and lower arm

 

[PurpleRT]

Stick a screwdriver inside (B) at an angle and hold it with one hand to prevent it from spinning while you tighten the nut down with your other hand

 

[HSKR R/T]

Pl

When I tighten A, B (and A for that matter) twist with it.

Maybe I am just unclear how to install it. the video I saw, and the instructions just made it seem like you drop it in and just tighten the bolts to the sway bar and lower arm

Place to put wrench in blue. Could also use a large crescent wrench around the B area

 

[1BADRAMLIMITED]

Pl

Place to put wrench in blue. Could also use a large crescent wrench around the B area

Yup this is what I did!