2022 DT Ram 1500 Limited (5.7 liter gasoline) located in Australia
I replaced the original 98 Liter with a 205 Liter gasoline tank but found that the fuel gauge needle position and Range (Distance To Empty) were incorrect.
Yesterday I was using the Windows 2.4.0.0 AlfaOBD tool set to "ECU's: Body Computer: DT MY2022+ PowerNet" configured with "Car configuration change > VehConfig 3-Fuel Capacity (36-290 L)" from 205 liters down to 130 liters (to see if any settings besides 130 and 98 worked). I have seen mention of "ECUConfig 4: Fuel Capacity" as being another setting in various "posts" but could not find it.
I was cycling the Ignition Switch between OFF/ACC/RUN and occasionally starting the motor. A couple of times before the battery was fully discharged (and "died") I saw the red Battery symbol but didn't realise what that meant as the RAM has a large battery.
I measured the battery and saw it was just under 12 VDC so I put on a slow "trickle charger" for several hours until it was "fully charged" (measured 12.9 VDC and over 14 VDC with the motor running). However, now everytime the Ignition Switch is in RUN or the motor is running I get the following error notifications
Cruise Control Unavailable Service Required
Service Antilock Brake System
Anti-Lock Brake System (ABS) Warning Light
Service Electronic Stability Control
Service Trailer Brake System
Service Forward Collision Warning (FCW) Light
Adaptive Cruise Control (ACC) Fault Warning Light
I have disconnected the battery positive connection for over an hour and been for a short drive but issue is still there
Any assistance will be gratefully accepted
I replaced the original 98 Liter with a 205 Liter gasoline tank but found that the fuel gauge needle position and Range (Distance To Empty) were incorrect.
Yesterday I was using the Windows 2.4.0.0 AlfaOBD tool set to "ECU's: Body Computer: DT MY2022+ PowerNet" configured with "Car configuration change > VehConfig 3-Fuel Capacity (36-290 L)" from 205 liters down to 130 liters (to see if any settings besides 130 and 98 worked). I have seen mention of "ECUConfig 4: Fuel Capacity" as being another setting in various "posts" but could not find it.
I was cycling the Ignition Switch between OFF/ACC/RUN and occasionally starting the motor. A couple of times before the battery was fully discharged (and "died") I saw the red Battery symbol but didn't realise what that meant as the RAM has a large battery.
I measured the battery and saw it was just under 12 VDC so I put on a slow "trickle charger" for several hours until it was "fully charged" (measured 12.9 VDC and over 14 VDC with the motor running). However, now everytime the Ignition Switch is in RUN or the motor is running I get the following error notifications
Cruise Control Unavailable Service Required
Service Antilock Brake System
Anti-Lock Brake System (ABS) Warning Light
Service Electronic Stability Control
Service Trailer Brake System
Service Forward Collision Warning (FCW) Light
Adaptive Cruise Control (ACC) Fault Warning Light
I have disconnected the battery positive connection for over an hour and been for a short drive but issue is still there
Any assistance will be gratefully accepted