ReadyLift SST 3.5 & 35x12.5x18 Issues

[HTX_Abel]

New guy here,
Setup:
Readylift 3.5 kit
Fuel Shoks 18x9 -12
35x12.5x18 Toyo Open Country M/T

So i just had a shop install my new Readylift 3.5 lift on my 2020 Rebel. I am having wobble issues at speeds higher than 50mph.
Just had the dealership replace the tie rod end links under a warranty service i was getting done. But didnt seem to fix the issue.
Both top hat spacer and pre load spacer are installed. I was getting mixed info on this causing issues but just wanted to make sure if there is anything else.

 

[2021REBEL]

I may be mistaken, but I am pretty sure you don’t use the spacer because the rebel has a factory lift. Contact ready-lift, they were the ones that told me you do not use the spacer on a rebel trim. I was going to go this route, that’s how I know, because I did extensive research into this kit.

Hope this helps.


Sent from my iPhone using Tapatalk