Readylift 2" level kit

[Another Money Pit]

Has anybody come up with a solution to cap the top of the UCA grease zerk. I live in a snow and salt area and am not wanting salt and other things to be getting into that area. Does anybody have a 3d printer and want to fab one up, I'm sure there would be buyers for these caps.

 

[theblet]

Something like this?
LockNLube Grease Fitting Caps (50 Count) (Yellow) https://www.amazon.com/dp/B0779K66DW/ref=cm_sw_r_cp_api_glt_fabc_JE92K17FTBRHF3S5S4ED?_encoding=UTF8&psc=1

 

[djevox]

I’m not sure why, but that link above doesn’t work so I’m adding it below

LockNLube Grease Fitting Caps (50 Count) (Yellow) https://www.amazon.com/dp/B0779K66DW/ref=cm_sw_r_cp_api_glt_fabc_1WEHA6A22B01E604TQVP

 

[Another Money Pit]

I’m not sure why, but that link above doesn’t work so I’m adding it below

LockNLube Grease Fitting Caps (50 Count) (Yellow) https://www.amazon.com/dp/B0779K66DW/ref=cm_sw_r_cp_api_glt_fabc_1WEHA6A22B01E604TQVP

Yea kind of, I was thinking the whole round cap area though. Kind of just like a lid on top of it so water and other things can't just sit on top of it. Think like a smaller cottage cheese lid.

 

[djevox]

Yea kind of, I was thinking the whole round cap area though. Kind of just like a lid on top of it so water and other things can't just sit on top of it. Think like a smaller cottage cheese lid.

Oh, I see what you’re saying, and I’ve never stumbled across that before (not saying there’s no possibility it exists though). I think that is something that would probably have to be 3D printed.