I still have to fab the two top mounting brackets and finish the
Filler neck mounting ring. Then it all goes to a friend to weld.
The size is 60"W x 20"T x 14.5"D. This calculates to 72 Gallons.
This is also sized for my 6'-4" bed. A 5'-7" Bed application would
need to accommodate the Wheel Wells after 5.5" of Depth.
Here is what I have so far:
60" x 120" Bright 3003 Aluminum Diamond Plate $455
Nivert Metal Supply, Throop PA
Brass Screen $6 (To make a filler neck screen)
Smarter Shopping, Better Living! Aliexpress.com
www.aliexpress.com
Filler Neck $37
Smarter Shopping, Better Living! Aliexpress.com
www.aliexpress.com
Diesel Fuel Pump + Spare $23
Smarter Shopping, Better Living! Aliexpress.com
www.aliexpress.com
Steel Weld in Bungs
SS Braided lines AN6 & AN4 4 feet of each
AN6 90º Fitting x 2
AN4 90º Fittings x 2
3/8 NPT to AN6 male Strait x 2
3/8 NPT to AN4 Male Strait x 1
1/8 NPT to AN4 Male Strait x 1
5/8" ID Submersible Fuel Line X 2 ft
Switch
2 conductor 16ga wire
Tap a Fuse
5.2 Gallons per inch
Malodave