Builtright Molle Bed Panels.

[H2OMAN]

First panel installed. Learning curve achieved. The other 3 panels should be easy tomorrow. Then I need to remove or mangle my heat shields so I can fit my 35 inch spare under the truck.

 

[Rsorrell2]

Nice where did you get it from ?

 

[H2OMAN]

Nice where did you get it from ?

Builtright.

 

[SD Rebel]

Here you go: RAM 1500 (2019 - 2023) Exterior - BuiltRight Industries

I was considering these during the beginning of Covid, but they were hard to get due to shortages, but thanks for reminding me about them again.

I love the fact you can get each section separately, you don't have to buy all 4 of them if you don't want to.

 

[H2OMAN]

All four installed. I haven't installed any mounts yet. The important thing is that I can better secure my Jackery next to the tailgate now.

 

[UnclJim]

I live my Built Rights I just did the 2 rears

 

[Humer91]

Have the set of 4 installed and love it. Spoke to one of their engineers and they are supposed to be working on a bulkhead panel for our trucks, also.

 

[J3diMastah]

First panel installed. Learning curve achieved. The other 3 panels should be easy tomorrow. Then I need to remove or mangle my heat shields so I can fit my 35 inch spare under the truck.View attachment 162898

Was this difficult to install with factory spray in bed liner? Looking to do this as well.

 

[ZombieSlayer]

Was this difficult to install with factory spray in bed liner? Looking to do this as well.

install video. It will be harder if you don't have the bedside rails installed and they sprayed over the threaded insert holes that are in the bed. You'll have to find those.

 

[J3diMastah]

install video. It will be harder if you don't have the bedside rails installed and they sprayed over the threaded insert holes that are in the bed. You'll have to find those.

Thanks for the info appreciate it

 

[H2OMAN]

Was this difficult to install with factory spray in bed liner? Looking to do this as well.

One of the holes was a little thick with liner but drilled out very easily. The supplied insert went right in after that. Installation is very easy.