4 Wheel Electronics Aux box

[Daniel035]

Does anyone recognize what kind of connectors these are? I originally thought they were bullet connectors but they don't seem to fit.

Sent from my Pixel 10 Pro using Tapatalk

 

[PdPuNOme]

I believe those plug into the main grey connector off the aux box. Found this link for upfitters, may be of assistance.

https://www.ramtrucks.com/BodyBuilder/service/Image?imageId=MtQrP%2FFqLY5r%2Fest8MtGjGgHzAHGUTU0WB3rWuqSY7YmQ2vEhuBWBOxu5ImnA5fd%0A

 

[PdPuNOme]

AUX pass-thru wiring.

Let me start by saying I am truly sorry for once again bringing this up. After I plug this harness in to the gray connector under dash the single wire is my pass thru #6? And than that loose wire can be hooked up directly to a device with in side the cab ? What do you all do with the extra...

hdrams.com

try that thread as well.

 

[Daniel035]

These are the pig tail wires coming off the relay box. I have everything installed and connected. They go hot when I push the aux buttons. I just want to know what kind of connectors these are. Their website shows spade connectors but these are not. I thought they were bullet connectors but they don't fit. I can cut them off and install new connectors but I thought I'd try these, just can't find anything that fits.

Sent from my Pixel 10 Pro using Tapatalk

 

[catrue]

I also have a 4 Wheel Electronics Aux box, albeit I did purchase used from a forum member. Mine had just standard blue crimp connectors on the ends of the aux leads (not all were used previously). Hard to tell from the picture, but those look crimp connectors with white heat shrink that has been heated on just the crimped side?

I ended up cutting mine and soldering Deutsch connectors with grounds so I can easily add/swap out accessories in the future.