3.5" Rough Country with factory 22's

[terrywarfield]

Wanted to share photos of the lift and new tires using stock 22's since I couldnt find many samples. Wasn't in the market to also buy new rims

Ended up going with Rough Country 3.5" lift (M1 struts), and Venom Power Terra Hunter XT, T35X12.50R22LT + .25 ready lift Spacers all around since the factory rims have a positive offset. Didnt want the tires sticking out a ton. These clear the fenders just a tad. No cutting was necessary either

For sure an immediate difference in acceleration and power output difference now tho, of course engine working harder

 

[CHeYeNNe71]

Wanted to share photos of the lift and new tires using stock 22's since I couldnt find many samples. Wasn't in the market to also buy new rims

Ended up going with Rough Country 3.5" lift (M1 struts), and Venom Power Terra Hunter XT, T35X12.50R22LT + .25 ready lift Spacers all around since the factory rims have a positive offset. Didnt want the tires sticking out a ton. These clear the fenders just a tad. No cutting was necessary either

For sure an immediate difference in acceleration and power output difference now tho, of course engine working harder

Looks good! Did you calibrate the speedo also?

 

[terrywarfield]

Looks good! Did you calibrate the speedo also?

Not yet. Just keeping in mind im about 5mph faster than my speedo shows right now til I get it done

 

[BryanRunsTrains]

Looks nice. How do you feel about the ride compared to stock?

Also, it's hard to gauge visual difference between stock, would you mind getting a few pics next to a stock Ram?

I'm currently on a 2" level and 285/50/22 Recon Grapplers and am kicking around going to the 3.5" RC kit.

 

[sgtmpeaslee]

I’ve been looking at this kit but had seen the negative comments about it and the concerns for safety. How has it been for you.

 

[firemedic10584]

Just installed the same M1 kit today on mine. Is yours nose high? Install went fine, but my rear end is still a bit sagging. I've read others ended up doing a 2" rear spacer instead of the 1".