Search results

Are the lvds the same for uc4 and uc5?

The one for heated steering will work and is much cheaper ($60), I think because of the recall. You just wouldn’t have a connector to plug in to the heated steering connection on the wheel side. I had both of them side by side and the rest the same, when I added heated steering...

For a 21 bighorn with heated steering, it was 68545657AB. Make sure you get one ending in ab since there is a recall on aa ones. This is complete combo switch with clockspring.

Might be dumb idea, but any chance it’s the driveshaft slip yoke bind/clunk happening at strange times. Also, many years ago I used chassis ears for some clunks, see where it’s the loudest to hone in on. ($110)

You might try buying Crutchfield install instructions (pdf) for $10 if they have them. Can be very helpful.

As I recall the instructions were correct with ANC, what I have. It doesn’t matter much with 6 speaker system, essentially 4 speaker output, however better on the rear. Then always can adjust to front to lower output to rear/sub with radio controls while driving. But bass control on equalizer...

I looked up the wire diagram on Alldata. In my case I could see I needed 3 power wires from right kick panel to seat/steering heat module, 2 wires to connect in can bus which go all the way to above left kick panel can bus star connector, 2 wires power and return for steering (ones I mentioned...

Clock spring 68545657AB Wheel was used and I was unable to match to updated number. But a new one is 6xs002x7ab I believe. They very a lot, but this should be all leather bighorn. I am not sure if it would work with just soft keys, I changed center stack.

On my 21 Bighorn, I had to run 2 wires from module to below center seat, and of course clockspring and wheel. But that was after heated seats all installed.

Any help would be greatly appreciated. Anyone on here have your old part numbers handy for uconnect 5 w/ nav 8.4? I am wanting to switch from uc 4 8.4 no nav to uc5 8.4 with nav for the hd fm signal. Non-nav are not hd radio, highly noticeable with good aftermarket system. Looking for the...

Anyone on here have your old part numbers handy for uconnect 5 w/ nav? I am wanting to switch from 8.4 no nav to 8.4 with nav for the hd fm signal. Non-nav are not hd radio, highly noticeable with good aftermarket system. Looking for the receiver and disassociated display part numbers. I don’t...

If you have amp that accepts speaker level input and has auto turn on sense, you won’t need a LOC. I still opted to use LOC LCI5Pro for better control with two amps. You also need inline resistors for the speaker output wires, if you don’t have in your LOC and running through amp. At least...

Thanks. I already have one coming, will see what happens when it finally arrives.

If I replace center stack having manual a/c , will the auto a/c just work or do I need to reconfigure with alpha?

I have the same issue. Seems like it has always happened, but much worse with all my speakers amplified which makes sense. You can turn volume down at the right moment, but then mine reverts back too. My radio even replaced under warranty, but does the same. I have a U4 8.4 and considering...

From what I understand you have to to upgrade to the 12 inch screen, reprogram bcm, and buy adapter harnesses. Mine u4 8.4 does not have all those connectors. I see on ebay these items sold. Personally I just want HD radio, hoping for the cheapest option someday. Does anyone know a quick easy...