Search results

Thanks for the info. I'm looking for a different set of studs for my coilovers to gain some extra length. I noticed that you said that FOX uses an M10x1.25 wheel stud, but the Dorman part you listed (Dorman 610-360.1) is a M12x1.5 wheel stud (so is the link you listed). Do you know if the...

Great looking truck! Did you do the 2.5 DSC coilover setup in the front and rear and completely remove your Mopar lift, or did you just install the DSC coilovers in the front? I have the Mopar 2" lift with ORP springs in front and was just considering doing the coilovers in the front to get it...

Great looking truck. Did you go with the 2.5 DSC coil overs in the front and rear, or just the front? I have the 2" Mopar lift and was considering only installing the 2.5 DSC coil overs in front to level it out. Would love to know your exact setup front and back. Thanks!

I've read through a number of these forums and still don't see if anyone has found a good solution... I have a 2021 Laramie and installed the 2" Mopar lift and ORP front springs. I still have about 1" of rake and would like to level it out. Anyone find a good solution that works? Thanks!

Thanks - when you installed the RC upper control arms, Do you know which part number you bought? Was it SKU #31402 from Rough Country? The reason I ask is that they are specific that it is for a 3" or 3.5" lift kit. I assume since the Mopar kit gives 2" and the ORP springs add another 1", we...

Sorry - swaybar. Darn autocorrect...

I've got a 2021 Laramie on order - does anyone know if the Hellwig 7883 swayer will fit a 2021? I called Hellwig and they say that they only have data through the 2020 model. Thanks guys - great thread. You've helped me a lot as I'm outfitting the new rig....

I’m coming off of a 2016 3.5L EcoBoost. At 120k of nearly all highway miles, the thing started coming apart. Had to replace the throttle body, all plugs/wires, passenger side turbo, and both side exhaust/turbo manifolds. Cost me $8k just to get the truck driveable again and now I’m...