Search results

My GW air compressor would startup’s when ever I unlocked my doors, once I noticed suspension adjustment not available due to hot compressor error I took it in for a service check, they found a bad front air shock bag leaking and ordered a new one.

I have air suspension and pressure my KO2’s (20”) to 36 psi, I adjusted the pressure to 3 psi over recommended pressures. when installed at 70 degrees as weather temps in NS will drop to well below freezing in our winters. They have flat spots from setting over night that smooth out in a few...

I stuck 1” rubber foam insulation used on AC lines,fits well helps keep out the rain and viewer from seeing what in the box. Stays on the tail gate though.

Actually it was. 40yrs ago. His point to me was allow the rings a chance to seat before going to synthetic, that was all.. as I was had just purchased a new car and was asking the same question everyone else does when to change the break-in oil out.

My dad was a mechanic for 40 yrs, claimed he had a new car come back in because it wouldn't stop smoking, found out the owner changed to 100% synthetic oil too soon as the rings didn't fully seat. So i like to have at least 8000Mi before changing to let the break in oil do it thing, oil filter...

just traded my 2016 eco in for a Hemi, i could use that money too.

I use the Wilson travel booster, comes with a magnet antenna,120 to 12 v adapter for inside camps or motels window suction cups for the inside antenna.

I suspect your shades edges maybe thinner simular to Weather Tech. Mechanics at the garage could not make the window go up with the installed mopar shades so removed them, I almost bought them but seeing how thick the edge was changed my mind. I took pictures of my old weather tech shades and...

This morning I visited my Chrysler dealer wanting a set of Mopar shades . They had a set of in-track window vents they couldn't installed on a new Ram because the window would not go up all the way. NOW if you see the edges shaved thinner they may work.. I asked to see their window shades and...

Great looking headache rack and lights you have added! Obviously you have patients by the time you took to wiring the lights exactly the way you want them. Doing a satisfying job like you did are worth the self-rewards, koodles to you again. Nice job.

I also added my blockheater and battery tender plug to my bracket too.

(y)

You’ll find if you leave the cord outside and drive on the highway that it can scratch your paint or head light as it did on my old ecodiesel when forgotten outside..

I installed the marine male plug this afternoon and it looks pretty good to me and semi permanent . Here a few steps I drilled the licence bracket hole 1-3/4' for a tight fit and use an extension cord to the heater plug.

I purchased one of the marine plugs, On mine i have to wire the 4-6' ft extension cord into it. Note it has drain hole to be located on the bottom, i might install attached to a tow hook for the winter only , I hate drilling a 1-3/4" hole in the lower grill too.

Temp. Fix to keep the weather out. Tucked weather seal under tailgate access cover to hold in place.

While I was installing the tap washers on the tail gate guides. I also installed temporary gaskets on the top tailgate gap for now, coating it with lots of mothers protector sealant for now until a more permanently fix is found.. ( I split the insulation and tucked it under the tailgate access...

Cool. I installed one on each side tonight and look evenly centred after closing it several times. Thanks

Ditto