Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Update: got my fuse tap in and moved remote wire to fuse 66 under dash.
Ran dedicated power and ground to LC6 instead of pulling from harness.
For good measure, I ripped out the harness and resoldered all my splices.
Not sure which it was but we now have working subs. My guess is leaning...
The ground/power to LC6 is the first thing I'm gonna swap tomorrow and then we'll take it from there.
According to a WaterFowler41 vid, using the GTO remote feature cause the LC6 to turn on and off periodically when the truck is off (as well as the amp if using remote out from LC6), as ANC...
I tapped into the green/green black, purple/purple black which are the rear doors. I tapped in at pretty much the same place it shows in the manual.
All splices were soldered and heat shrinked. I bought 40ft of 9 conductor speed wire, all of the colours match the colours on the harness for...
No worries man, I appreciate any and all help given. I've really got nothing else to go on until I test at the subs/amp/loc either tonight or tomorrow. If I can't get anywhere with that I'll start by pulling out the harness and my run of wires, cutting off the splices and starting fresh, taking...
That's the route I was going to go until I found out how hard it is to find a micro 2 fuse tap locally. I'll be swapping the remote wire source once the fuse taps comes in.
Maybe, but could it be that the system is cutting me off at the splice because of a difference in impedance?
When I was speaking to Audiocontrol earlier, they suggested I get AC-LGD 20, which to me essentially looks like a resistor pre rigged on their blocks.
Could the source of my remote wire to the LC6i be an issue? Someone on another forum had mentioned that this could be a problem and to grab my remote from the back of the factory HU.
Am I right in thinking this can't be the culprit because remote goes to LC6i which has a remote in and remote...
After reading through the "stock stereo" thread I see people mentioning resistors. Post 818 mentions 50 ohm resistors at the LC6i inputs.
I see that audiocontrol has the ac-lgd 20 which I'm assuming is pretty much the same thing. Audiocontrol says they are 20 ohm. Does the ohm rating of the...
Hey guys, in need of a little help.
So I have a 2020 Ram Rebel with the base non-nav 6 speaker system.
I'm adding a mono amp (Sundown SFB-2000D) and two 10 inch subwoofers(Sundown SA Classic 10"). All of the factory speakers are going to remain stock for now.
I went with the LC6i as my...
I bought mine from Peel Chrysler in Mississauga. I heard mixed reviews about the place, my experience was pretty good though.
For the area I was looking, Peel seemed to be the cheapest. Could have probably got more bang for my buck if I traveled a little out of the GTA.
Hey guys, new Ram owner here out of Ontario, Canada.
Picked up my 2020 Rebel 5.7 about a week ago and loving it so far.
After seeing some of the members trucks on this forum, it safe to say my wife is gonna kill me one day. A lot of nice trucks on here.
Cheers guys
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.