Search results

HK system here. I’ve been reading other threads regarding the dash speakers also being out of phase and that reversing the polarity on the Metra 72-7902 provides some benefit. Has anyone come across this?

Got my truck in July 2020, I’ve got plates and all right away but CA DMV doesn’t have my title on file which is fine since it’s not required until the truck is paid off in a few years. Thank you though for the insight!

I also did this last year, from Arizona. The only thing I’ve yet to do is submit the title from the Arizona dmv to the CA dmv which I’m a bit confused on how to do since I’ve never had any contact with Arizona dmv.

Realistically how difficult would it be to replace the usb media hub oneself? I don’t want to risk going to the dealer and having them cause other issues while it’s there.

Hi everyone. I purchased a Truxedo Sentry CT for my Rambox bed which was listed by Amazon as “like new” for a really good price. I just got it yesterday and it looks brand new, never mounted just open box. However, it is missing all of the clamps that connect to the bed rails. Amazon offered an...

Hi everyone. I’m coming up on the one-year of my out of state purchase on my 20 Rebel. It’s never been to the dealership, I’ve done my own oil change (synthetic) and replaced the cabin and air filters. Is it worth taking it to the dealership to have them check anything else that I can’t manage...

My apologies. Here’s the right part, it is M10x1.25 https://www.autozone.com/suspension-steering-tire-and-wheel/wheel-stud/dorman-wheel-stud-610-308-1/156860_0_0

I run low speed at 4 and high speed at 2 front and back. The ride does change quite a bit in my opinion but I can’t seem to settle on how I want my truck to ride. On a side note, is it just me or are the high speed clicks super hard after about 6 or 7? Like 2 hands to twist hard?

Assuming you meant 3032? I ran into the same issue. I did end up drilling the holes in the plastic to mount them.

Hi all. The passenger front headrest on my Rebel (“leather”) rattles a lot on bumpy roads and is pretty loud. There’s a bit of side to side play as well. Anyone else dealt with this and have a recommendation? Thanks so much.

That’s great to know. Would you have advice for factory part numbers on the Rambox version?

Exactly. You lose the extra inch removing the factory springs.

2 inches of lift on a Rebel when set to max preload of 1.5 inches exposed thread.

Hello everyone. Has anyone found the Rebel bedside decals cut for the Rambox like the photo below? Every one I’ve seen is for the standard bed unless that’s it and creative measures are needed to make it fit. Thank you very much.

Anyone know if the Metra 72-7902 harness that’s used for the front dash speakers will also work on the rear headliner speakers? Thanks so much.

+1 on keeping the factory Duratracs until they’re worn!

Anyone know of a version that’ll fit RamBoxes? Thanks!

No need to send them back. They can send you the parts and any shop should be able to install without issue.

Sorry man, welcome to the club of missing parts 🙄. Fox will get the missing parts out to you, figure about a week. Just make sure they send parts for both sides- they missed that small detail with me.

Sure did. An extra 0.5” of preload for 3” total or 2” above the stock Rebel height.