Search results

Hello, I installed a S&B 55Gal Tank on my 2022 Ram 2500. I was able to get the fuel tank size reset but the fuel gauge is not working or the DTE as is should. For example it shows I have 1,000miles remaining I have already went 400 I do average 18-20mpg (HWY) most of my driving so the...

Hello, I installed a S&B 55Gal Tank on my 2022 Ram 2500. I was able to get the fuel tank size reset but the fuel gauge is not working or the DTE as is should. For example it shows I have 1,000miles remaining I have already went 400 I do average 18-20mpg (HWY) most of my driving so the...

I was able to go the body module and then vehicle config to change the tank size. It didn’t work at first just stated “low” on the DTE. Went back home hooked it up again reset it to factory then back to 208liters then it worked.

Anyone have a writeup on how to change the Fuel tank Size just upgraded to a 55gal S&B on the mega cab I though I had it bookmarked but I don't and my cell phone google fu is not on it today its a 2022 Ram 2500 if it needs to be specific.

Well finally took the time to do my ceramic coating 2 days of polishing and then two coats of car pro quartz and 2 coats of gtechniq sealant and wow so beige and smooth. Also fly by 30 on all the glass and coated all the rims and plastic and up guard on tonneau cover

Got me some new rims and tires Anthem Rims in Bronze Cooper AT3 Tires

It was today I replaced the harness and it works perfectly. Then today I installed the front bumper and I can’t use 2 sensors so now I have a code for the front lol but I know why it is. Can this be cleared so the messages goes away even though the 2 sensors are missing

I replaced that one today with a new mopar one from dealer also didn’t see any issues with the harness maybe I will pull back the coax wrap tommorow and check to see if it crushed a wire when the trailer incident occurred

From what I have found so far it’s the 3rd sensor from drivers to passenger side or the one closest to the hitch on the passenger side

Thanks that was my problem I found the Fault keeps erroring on this one B1297. I will research tonight to figure out which one that is on my bumper and go from that point. Anything helps me I'm new to this hole thing I need sidewalk chalk at all times :)

Yeah I can’t find just park sense in my list I found an evic option in commercial settings but that didn’t have the option either

Yeah i tried the he section won’t allow me to post but the process should be the same for the install

So a few weeks back my trailer came off and smashed into my rear bumper. Short story used the wrong ball in the wrong trailer and boom lol. So anyway it looked like it hit a sensor and I immediately got the error message shown. I replaced the sensor and disconnected them all and reconnected...

found this not sure if it will help

I beleive to install this one you have to remove the instrument pannel

Okay I wasn’t sure if it would be ok to leave it and drive around all connected

Anyone installed one of these? I looking at one because I will be adding a FabFours front bumper and 12k winch so figured this would help lift the front end back up. Also if you have installed it could spring compressors help so you don’t have to drop down the axle...

Thanks everyone was able to make that change just did a test drive no codes and lights are all working after the change.

Yeah I should have clarified I dowloaded my log etc did not mess with any settings was looking at all the options etc... Thanks I have been googling videos just got home so my laptop makes it much easier lol. DO you guys leave it all connected and just uninstall before the dealer? By that I...

So how do I actual make the change? Messed with it for a little while today I have my log file downloaded so do I just change the log file and upload a new file back to the truck?