Search results

Just installed these CDT wide bands into the dash corner locations

Same thing with mine, the plastic side rail caps are bowing from just the rack itself.

When I lay material on top of the tailgate like in the pic, I don’t use the ratchet straps to tie down the material. I only use them to secure ladders and other materials that are on top of the ladder rack.

Curious to know if this is a common problem with the bed sides? Of all of my work trucks that I have had, none have had this issue.

Does it need to be a 500 amp isolator or will a 200 amp one be enough since my setup will be for 3k/4K not 8k like yours?

https://www.down4soundshop.com/down4sound-d4s-lto-6-0-12v-lithium-battery-3000-5000w/ I found this one to maybe use as the secondary battery. It says that with my 220 amp alternator it should handle a 3,000 - 4,000 watt system. But I wouldn’t know what isolator I can use for this setup with the...

They have these heat shield kits available, not sure how well they work. https://www.jegs.com/i/JEGS/555/10268/10002/-1

I’m trying to see if anyone has upgraded to a lithium battery under their hood. I’m going to finish my audio system upgrade and I plan to only run an XS Power lithium battery in place of the stock one. I already upgraded my alternator to a 220 amp factory one and with the battery I’m planning to...

The only reason I am planning to run new 14 gauge speaker wire is, I’m planning to put over 100 watts to each speaker and possible mid upgrade later to over 200 watts.

I say go with dual 10’s. I started with a single 12 but that didn’t last too long. I also need to make time to rewire all the speakers to 14 gauge, then get my 300 amp alternator and xs power battery before I can finally tune it to full power, 3500+ watts rms.

https://www.idatalinkmaestro.com/en/accessory/768/HRN-AR-CH4 Make sure u get the T harness also.

The AR is also compatible with Audison and Audio Control amplifiers with DSP built in, if the kenwood amplifier isn’t available.

You will not need the PAC module, the AR uses the same T harness as the DSR1 to connect to the factory harness and also it will have speaker wire leads to connect to the amplifier. AR DSR1

I have a 2020 Big Horn with the Alpine system and I used the DSR1 to integrate my aftermarket amplifiers. There are a few issues that it has but other than those issues it works great. First issue is the Bluetooth failed connection on the app start up and the second is that it doesn’t play well...

Upgraded the big 3 for the electrical system to 1/0 wire

Ace English Bulldog Blossom Yorkie Poo

The thing about car audio, is that it’s all subjective to what sounds good. So I would say to customize it to your sound preference and your budget. With that said I found the best way for me to fully customize my truck’s audio, was with the Rockford Fosgate DSR1. The only draw back to using...

I installed the new subwoofers. Breaking them in with about 1,000 watts @ 4 ohm, set with a 40 Hz test tone to 63.24V

I have been looking at some of these HD springs for my truck, since I’m usually hauling material. But I have yet to pull the trigger, so idk if it will actually work...

And they are easy to make if you do plan to take it to a shop or installer, they should be able to raise the seats for you.