Search results

Are you just wanting some pictures of the truck after the spacers were installed?

I have the Safety Group on my Laramie, and have noticed no adverse affects from my 2" front, and 1.5" rear, spacer lift.

If anyone has time, my biggest curiosity is whether the Mopar 2" lift kit is changing the front end geometry the same way as the above pictures in regards to the steering stop strike area. Could someone who has the Mopar lift installed take a picture of their steering stops? I would mainly like...

Just curious, is everyone with a leveling kit (air suspension or standard coil) seeing the same metal contact/wear that is posted in the pictures above?

I didn't modify any of the heat shield around the tire, it managed to fit up there without any issues. In regards to your service adviser, I want to say that there was an issue on the 4th gens about fitting a full size spare. For sure I think there was an issue fitting a stock wheel on the 4th...

What you listed were my concerns as well, especially in regards to being off-road somewhere remote that you might not want to run a temp spare. I went ahead and replaced my 18" steel spare with a stock wheel (Painted/Polished Aluminum 20") paired with a matching BFG KO2 275/60R20 tire. I was...

Yeah I hear ya, I tried to dig through this forum quite a bit on deciding whether I needed new UCA's as well. The water got muddy as well in regards to what, if anything, was different in regards to stock UCA's versus the Mopar 2" Lift UCA's.

I didn't change out the UCA's. After seeing that they were the same as the UCA's used on the air suspension setup, I elected not to change them. After install I felt comfortable with ball joint and overall angle. But, I don't have the ORG option, so it's just 2" over stock ride height.

I don't have any photos, but yes it is the same one as the 4th Gen kit. I ordered off of Amazon, but reached out to Motofab prior to ordering. They confirmed it was the same kit.

Yes, it sits at the bottom.

Obviously ride quality is a bit subjective in regards to what everyone describes/observes, but overall it is still very similar to stock. I've noticed a slightly stiffer ride over bumps in the road though. As a comparison, this truck still rides smoother/softer than my 2015 Ram 1500 with air...

Hey everyone, Couldn't find much for pictures showing a Motofab 2" FT / 1.5" Rear spacer kit installed, so I figured I'd post a couple up just in case anyone else was interested. Forward rake is about 1", which is what I was hoping for since I tow with the truck. ** First picture is stock, the...