Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
The pins were not correct unfortunately. But, I found an additional benefit to having this console shifter. When you put it in drive and then shift left to S mode, it disables engine stop/start. It's nice to have a simple, and intuitive, on-the-fly method of stopping the stop/start from...
Maybe, but I think there could be residual water in the tank even knowing that this is true. The other possibility is that the pressure sensor was acting up. I also wonder if bad gas has a higher density than good gas. Not sure how that would be understood.
It has to have some sort of...
Exactly. But water may explain why it happened as the level went down. When the level dropped closer to the pump the water to gas ratio may have been enough to cause the issue.
*** edit *** I should have said they help the water burn out of the system
There are some additives specific to removing water from your fuel system also.
So, technically the pump assembly is mounted on the top side of the tank and draws from the bottom. So it could be that there was water in the gas and when it reached the lower level of fuel there was too much water remaining.
I am old, and I remember water in gas causing major damage to cars...
That is all fine and good when getting gas from a reputable station. However, if he did get gas from a station that isn’t properly filtering their gas, or introducing water into the gas, it could settle at the bottom of the tank, and might explain why he didn’t see a problem until the tank was...
When the gas gets low, anything at the bottom of the tank will get pulled into the fuel system. Maybe there were contaminants that settled to the bottom of the tank.
I am ok with the school zone cameras. Anyone speeding through a school zone deserves what they get.
Georgia law allows speed cameras to be used in school zones to issue speeding tickets to drivers who exceed the speed limit by at least 10 miles per hour. The cameras can be enforced during the...
This is a fused switch ignition feed:
Pin Information
Cav
Circuit
Gauge
Color
Function
1
F919
0.75
PK/BG
FUSED IGNITION SWITCH OUTPUT
XY430A also has additional power feeds:
1
F917
1.0
PK/VT
FUSED IGNITION
9
F918
1.0
PK/BN
FUSED IGNITION
If it’s the same circuit you should be able to just tap into it at the nearest junction. I guess I need to get a harness out of a wrecked Ram now too. I don’t have the wiring and pins to make it all from scratch.
Sent from my iPhone using Tapatalk
I had the console apart yesterday so I compared all the connections on the console harness to what my Bighorn harness has pinned. I discovered at least two circuits that need to be pinned for the rear seat heated and vented seats. Circuit A207 is the Fused B+ for the switches in the center...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.