Search results

I did. I originally had Readylift to get with spacers. When I swapped out the 6112s and 5160s I left the UCAs in. Might as well do it right.

Why? The 1500 can’t carry a load heavy enough to warrant dual wheels on either side. What are you going to do - fiberglass bed? 12” flares? Will you upgrade the axle to support the additional load?

I have a Garmin inReach tethered to an iPad mini. Setup in my Jeep. Haven’t really used it yet though.

That was up in the mountains by my in laws. Above Pioneer, CA. I was just following my FiL, I think it was the Omo Ranch exit. There’s tons of forestry trails up there. We just drove around and went up and down the mountains whenever we found a road. Some were dead ends, so we stopped and turned...

Those are nice. I have zero welding experience. At some point I may get a set of sliders. Or just use my Jeep - that’s why I got it!

I kinda wish I had gotten a Rubicon. I built one with the same level of comfort as my Rebel (for a Jeep at least) and it was about $10k cheaper. So instead I got a TJ. Rebel for comfort. TJ for wheeling.

Gotta say - that looks like you have a bed sheet laying over the seats Any reason you have to have covers? There are covers that really fit much better.

I did. It worked out well.

Putting the pig through the tough stuff! (should’ve have taken the TJ)

Went out on a trail with my father-in-law in a spur of the moment decision. I wasn’t paying attention I was driving and drop ped the front end of the truck right into a ditch. Put it in 4 low, hooked up to my father in laws Jeep and he slowly pulled me out. Then went and continued on some trails...

Picked this up over the weekend. 2003 TJ. I6 5sp manual. 88k miles. Except for the wheels it’s bone stocks and does not appear to ever have been off road. was used as a tow behind vehicle fir a retired couple in an RV. I will build into a mild trail rig With by sons as a project. Just some...

Bought something to tow with the Rebel - Pictures are before I gave it a good cleaning. Going to be a mild build for now. Will be a fun project to build up with the boys.

In some ways I wish I had bought a nice new Rubicon Unlimited. I built went out with every option I would want. They really fully loaded one. Beautiful blue color with a tan seats. All sorts of great options. MSRP was close to $10,000 cheaper than a Rebel. Now obviously they are really two...

N nope. Cleared the calipers fine and I have zero vibration or problems.

Nice tips here. My oval muffler came in this week. Ordered some of the high temp silicone sealant mentioned above. Plan to install next weekend.

Have you tried disconnecting the battery for a while?

I have mine Line-X’d. Love it. Definitely a rough surface though. If I didn’t have a Bed-Slide mounted, I’d grab a rubber bed mat most likely.

Good looking wheels. What kind are they?

Why couldn’t you just ask them to remove the tracking device at the dealer put on? you ask them where something was and they said they didn’t know and you got super pissed about it? unless there’s a lot more to the story it sounds like you’re greatly overreacted and were really upset with them...

Mine did not. i think it’s an option for every level, but they automatically check off that option for the highest trims. But you pay for it no matter what.