By chance do you recall the wire colors for each sub coil? And are they 2 ohm coils?I dropped the ball and don't seem to have a close up picture of the sub wiring. The factory sub is a dual voice coil subwoofer. If you pull the sub from the enclosure, you can identify the left and right pairs. They wiring inside the closure is a different color from the wires feeding the sub plug. This picture at least shows the sub enclosure and wiring connector.
View attachment 193982
I’m just looking to connect a sub to the factory amp for now until PAC builds a module for it. I got an audiofrog 12 that’s very sensitive so it should be fine for a while. I have two pairs at the sub. Green brown/green white and grey brown/grey white. Obviously the greys are a pair and greens are a pair, just not sure which is positive and negative.i have a 2019 with the alpine so the harmon and the alpine are the same as far as i can tell from 2019-up so the bast thing to do is forget about the amp pro get a dsp and remove the factory amp totally there are 2 plug and play dsp's all the work is done under the driver seat
rockford dsr1 and the Hertz SPL Show S8 DSP i went with the rockford
i think you wrong it's opposite the whites are a set and the brown's are a setI’m just looking to connect a sub to the factory amp for now until PAC builds a module for it. I got an audiofrog 12 that’s very sensitive so it should be fine for a while. I have two pairs at the sub. Green brown/green white and grey brown/grey white. Obviously the greys are a pair and greens are a pair, just not sure which is positive and negative.