5thGenRams Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Center console conversion?

The plugs in question from the above post

I have tested the two 4 pin plugs in the rear of the console. usb hub does not work with either of them, console lid usb works with both. power in the wiring does not appear to be an issue. my current assumption is the USB hub from the swap in console was bad.
I have received a new rear usb hub.. still no luck getting it to work. apparently the wiring to power the hub and the wiring to power the console lid are not the same. Does anyone have any suggestions to get this hub powered?
 
I have received a new rear usb hub.. still no luck getting it to work. apparently the wiring to power the hub and the wiring to power the console lid are not the same. Does anyone have any suggestions to get this hub powered?
Take a look on page 26 from the pdf I put together on this post


for the rear USB's there should be gray connector that powers them
 
Take a look on page 26 from the pdf I put together on this post


for the rear USB's there should be gray connector that powers them
I was able to get everything working. My issue was that the console I purchased was out a 22, and my truck is a 20. In the harness I have the rear usb gets acc/ignition power on wire 17 that on previous models was for the cd player.. Once I tapped that to pull from 4, I was ok..
E12 seems to not be feeding power to illuminate the plugs, but my gut says that has more to do with the ambient lighting being missing. It charges which was the important step
 

Users who are viewing this thread

Back
Top