Recent content by WillySwan

Do you have the MFT on your Longhorn? From what I see, that is the part number for use with multi-function tailgate. Sent from my iPhone using Tapatalk

I DM'd Ram Cares on 10/31 this year and had a response on 11/1.

I was able to fit a factory OEM Rebel aluminum wheel in place of the steel spare on my 2022 Rebel. No modifications required. The key to getting it to fit is to let some extra cable out on the spare tire carrier winch and fit the spring through first then slide the rectangular retention plate...

Same thing here. I first set "CBC Config I/0 Bed Light Switch Input Present - Pin G16: -> Yes". When I went to set "CBC Config I/0 Connector F Pin 6: Baggage Compartment Lamps Output Present -> Yes", I got a notification in AlfaOBD that it was already set to Yes.

I installed the factory bed lights on my 2022 Rebel earlier this week. It was very straight forward. Instead of using the Mopar bed light kit (p/n ‎82215272AB) which requires running wires up the BCM in the cab and repinning a connector, I purchased the two factory wire harnesses that are...

Completed the installation this morning on my '22 Rebel. The parts above worked perfectly. As mentioned elsewhere, the left-side (driver's side) is very easy and is a good starting point. I had to deal with zip tied the air lines from my Timber Grove air bag assists on the right-side jumper...

I ordered parts from BAM today for my 2022. Note that the part number for the left side light has been changed from 68312567AB to 68618373AA. I will report results of my install when complete. Part Number Part Name Price 68312566AB Lift-Gate Lamp, Right $25.65 68618373AA Lift-Gate...

@RockYacht2020 - Have you installed your Anderson plug yet? Any details would be appreciated. I'm in the planning stages. I would like to be able to power a 40A DC-DC charger in my travel trailer. Here is my current thinking for truck-side wiring: - 6 gauge copper cable from battery 12V+ to...

That seems really strange. 54A provides constant power...correct? I have my MagSafe charger wired into the center console power outlet circuit but with the fuse set to position 54B (on/off with ignition). It works as intended.

These cup holders. They are firmly installed in the existing cup holders, are easy to remove, and they work with everything from a Yeti Rambler to a 12 oz. aluminum can. The aluminum can is a bit loose, but I've never come close to having anything tip over and spill. I keep them installed all...

Go Rhino Dominator Xtreme DSS Side Steps with custom step extensions. I really like the design and that the mounting brackets do not hang below the rails. These definitely are not sliders, but they are reasonably heavy duty and may be able to absorb a sacrificial hit and protect the cab from...

Rebel: ✓ Dweller: ✓ The problem is that they are currently halfway across the country from one another. I’m working to remedy that soon. Tangential to the thread topic, the running boards (not sliders) are Rough Country DSS. I like the look, but the profile is too narrow to really...

I’m sold. Sent from my iPhone using Tapatalk