Recent content by TJ1789

Yeah but it doesn’t make sense lol. 2wd shouldn’t get more lift than a 4wd and a 4wd shouldn’t equal the lift of a Rebel because of the springs used. Maybe I’m wrong but I believe it’s a typo.

This probably is not the reason you are a 1/2 inch higher on one side, but I believe Eibach’s lift diagram is off. Guys on this forum that installed a few months ago were getting the height mentioned in their old instructions (the photo w the lift on the strut). Recently, Eibach revised their...

We’ve had a few hard rains and there isn’t any water coming in. I hope it stays that way.

I just got my truck back last night. I’ll monitor it and get back to you.

Thanks for the response. I won’t force it off then…

I got the drip… and the crack. I just picked up my truck from the dealer, they replaced my rear window under warranty. My goal was to get it back from the dealer then put the marine gasket around my 3rd brake light. I can’t get it off. Is there a trick to removing the 3rd brake light? I’m...

Thanks man. That’s what I am going to go with. Definitely the stance I am looking for.

Looks good man. Once you get the ORP rear springs it will look exactly what I’m looking for. How do you like the ride w the Eibach’s?

Looks real good. Before the install what was your rake and how much height do you think you gained on the 1.8” slot?

Since the Bilstein’s are probably out of stock until Tom Brady retires I wanted to start a thread on the Eibach’s and how much lift everyone has gained- There’s basically 3 options: Eibach Adjustable Struts Only- with stock coils. Eibach Pro Lift- Struts plus Eibach Coils Eibach Struts Only...

Does anyone have pics on setting 3 with an ORP?

Has used tail light covers like the one below? Do they interfere with the blind spot sensor? Korlot Rear Taillight Tail Light Lamp Cover Trim Frame For Dodge Ram 1500 2019+ https://www.amazon.com/dp/B08CXRB5G3/ref=cm_sw_r_cp_api_glt_fabc_FGEWGBC1V22508Q0BPN2

Recently dinged up one of my powder coated gorhino running boards. I’m looking for a good recommendation on how to touch it up and still have the matte black finish. I’ve never used the rubber peel paint. Has anyone had any luck with it or is there something else better out there?

New hemi owner here. Is this the main reason Ram recommends using the 89 gasoline for the 5.7 hemi? If the grade of the gasoline is a factor what grade of gasoline are you boys using when you give your catch can measurements?