Recent content by scottmoyer

I don't know if they get replaced as a pair. I didn't check after they were replaced. There are two part numbers and you can separate each from the bracket. If I was out of warranty, I would have bought aftermarket and wired in the horn that needed replacement.

Have you looked, or even called around?

My high note horn died and was replaced under warranty when it did. It's easy to replace. Remove the clips that hold the plastic cover on at the front of the engine compartment. You'll see the horns on the radiator support. Remove and replace. Simple electrical plug in.

Below is from another thread I found on this forum. I found some on other forums also, but I don't know if I can post links to threads on competing forums here. This was in response to not seeing any threads about it. I stumbled on one and reserached for the others...

I found those also on BAM's site. When looking at part #7 and #20, you'll see they call them different things for the same part. They call them "console panel" and "shifter bezel trim". There are 3 part numbers and I assumed the higher priced ones are leather covered for the Limited, but I...

My truck is in mint condition except for the finish failing on my console plastics. You can see where I already repainted the slider and the matte finish came out darker and shinier than it should have, but the same thing happened there, where paint just started flaking off.

Anybody an expert on parts uinvestigation? The center console trim pieces on my truck are starting to bubble. I've seen others say the same. Doing a search for parts, and Mopar parts companies have multiple part numbers and names for the same parts. I know of 3 different trim pieces for the...

Is there any way to access those screws without removing the console? The finish on mine are starting to peel. I'm thinking I might just smooth them out and wrap them with vinyl.

It was easy to fix. The process is defined in multiple posts here on how to do it. Youtube videos also show how it's done.

The cab mounts aren't worn in most cases. They were just poorly designed having rubber isolates only on two sides of the mounting bolt, the front and rear. The banging is when there's articulation causing the cab to shift side to side. The new designed bushings have the rubber all around. On...

I don't have a pole barn, but I do have a lift. There are benefits/drawbacks to all lift types. The 2 post is mainly a service only lift. The 4 post can be used as a storage lift for stacking cars. Most quality 4 post lifts come with a rolling jack tray. You only need to buy the scissor...

I've had the Viofo A119 v3 for a few years now and the picture quality is great. I only pull video when I need to, so I don't need all the tech that some of these give. I use it for the purposes of protection when driving, so...

Remove the badges from the doors. That should leave just the grill and tailgate. If you don't have rear fender liners, install them. They are cheap and will keep the underside much cleaner. When pressing the brake down firmly, isn't your foot doing the "hold"? I'm not familiar with a brake...

After reading this and researching the same for my '21, I found that I could call SiriusXM Guardian and request that they disable all telematics. The agent said that it was very easy to do and it took just a few minutes. She said that she disabled access from the in-vehicle WIFI and the AT&T...

I don't know if the same is true for our trucks as it was for my old Mustang, but the Metra wiring harness adaptor for the Mustang required me to repin them as the wiring was also reversed. I think I've heard some here say the same is true that you need to repin the connector for it to be plug...