Recent content by rwo978

I never ended up getting instructions for this. The heater insert goes behind the heat shield and behind the starter on the drivers side, it was a bit of a pita to get in there. You’ll need a bunch of socket extensions to get the starter loose. Running the cord is fairly straightforward...

ALFA Obd changes. Connect to the BCM. Go to the Active Diagnostic and select the Car Configuration Change. Search INVERTER Skip the first VehConfig 2-power. That appears to be for a switch, possibly for the RamBox. All of the other ones, switch to YES. Some of these might be for the...

After over a year, I finally have this all installed and working. You'll need 3 additional parts: the In-dash inverter and 2 outlets (Part # 56046934AA) for inside the console and on the rear of it. I found all mine used online. Start by removing the dash infotainment assembly as is described...

Or turn off the wireless CarPlay in the Uconnect 5. Hate it and it's so glitchy. I'll plug it in old style, works fine. But the wireless interferes with my drivecam, which can only be connected to one wifi device. And so it then doesn't connect to either.

Figured out the cab inverter. I had everything right, just needed to add the fuse (F60) in the cab panel under the steering wheel. I couldn't find the specific fuse anywhere in town and the stealership had to order them, so I have a jerry-rigged fuse holder for now. I also found the bed lights...

5 worked. Seatbelt message still shows up on the dash though. Anyone have the info for the in cab inverter and the bed lights?

Post in thread '2023 disable seatbelt alarm?' 2023 disable seatbelt alarm? I did some Google searching. 21s seemed to still work. 23s didn’t. And 22s seemed to be 50/50. Could be maybe a tweak to a setting pushed out during a software update. I dunno. I’ll try the sequence again. I also found a...

Not for the 20's and newer. Worked on my 19, but not on this 22. Its in the computer, has to be deactivated.

Finally got an AlfaOBD setup for my birthday. Truck is a year and a half old, finally getting to changes. I was able to find the instructions to change the fog light dropoff to off and activate the brake controller I added, works fine and comes up on the dash. What I couldn't find...

I installed a used inverter and the 2 used plugs last summer. This would be the inverter mounted in the dash and the 2 plugs in the console, not in the RamBox. They have to be activated either at the dealership or with AlfaOBD. I just got the AlfaOBD setup for my birthday and was able to get...

Does anyone have a copy of these they’re able to post? I’ve scoured the page and the internet and have been unable to find them. I’m sure others would appreciate the link as well. My biggest question is path to route the plug/cable so the mopar oem clips are useable. Installing this on the...

We used another jack under the LCA and after a pump or 2, the strut stopped compressing and the whole truck started lifting. So that was a no go. I watched another video that mentioned swapping the struts from passenger to driver and vice versa, as the struts didn’t like being rotated 180...

Anyone that did the Motofab 2 inch spacers for the front have issues getting the UCA down far enough and the bottom up enough to send the top ball joint home? Messed with this for 4 hours this weekend and finally gave up because 2 grown men :) couldn't pry up and down enough to get them to line...

On the right side inside the dash, taped up around that cable with the 3 leads at the very forefront. Should feel like a bulge/plug under the tape.

Ended up finding the parts on eBay for the pigtail and Digi-Key for the other end and pins. Got them built and they work perfectly for what I needed them for. I’ll attach a parts list later.