Recent content by Rob M-O

Well, I answered my own question. I had the front bracket tight to the bed liner, but the bed liner wasn’t tight to the truck bed. I loosened everything up and leaned hard against the liner and then tightened the side rails. It closed the gap and got me the extra 1/8th inch I needed.

Just installed a Revolver X4 tonneau cover on my Laramie, with no ram box and it fits great. Until I close the tail gate. I have a drop in bed liner and the tail gate panel hits the latch bracket on the left side. I checked and rechecked to make sure the side rails are pushed all the way to...

WheelerNation, I’m a first timer too and just joined up. Already learned how to install a rack so I can transport my canoe. Next is a tonneau cover. This place and the people are awesome. So much to learn. Welcome from a fellow newbie.

I figured it out! Thanks for the tip B-Rebel. I’m excited.

Ok, that makes more sense. With the rear pocket, the rubber block will expand against the plastic bed cap before it hits the metal, right? And that’s ok? I cut out the plastic out from about a 1/8 to 1/4” down.

I’m attempting this install and it seems the bolts are about 1/8” too short to get the rubber expansion block under the metal lip. I’m afraid to loosen the rectangular nut too much and have it fall inside the bed wall if I wiggle the bolt too much. What’s the trick? All the pictures and advise...

I know this is a six month old conversation, but I just had the same thing happen to me. At a stop light, car in front of me goes on the green and I start to follow and bam! My truck decides to stop, hard. So glad I wasn’t rear ended. Now I need to figure out how to adjust or turn off the...

After driving small SUVs my whole life, used ones at that, I finally bought myself a new truck. And I love it! Now I’m looking to add some accessories to it and this site looks like the place to be. I’m looking forward to learning from everyone here.